PHILIPS 929003056001 Hue Adore Chrome BT Up-and-Down Mirror Light User Manual
- June 9, 2024
- Philips
Table of Contents
PHILIPS 929003056001 Hue Adore Chrome BT Up-and-Down Mirror Light
Product Information
The Philips Adore Hue Wall Lamp is a chrome-finished wall-mounted luminaire that comes with several components,including a base, plastic sealed housing, deco plate, deco ring, reflector, washer, LED strip, driver, Hue Connect, screws, cp3.2 washers, terminal block, and a waterproof plug.
The luminaire is designed to be detached from the mains socket and the DC cable should always be detached from the power supply to avoid any hazards. Staring at the operating light source may cause eye injury.
Product Usage Instructions
To disassemble or dismantle the Philips Adore Hue Wall Lamp, follow the steps below:
- Use a screwdriver to unscrew two screws[16] and remove the plastic sealed housing[2] from the base[1].
- Unplug the terminal block[14] and waterproof plug[15] from the plastic-sealed housing[2].
- Unscrew two screws[12] from the base[1].
- Unscrew two screws[11] from the base[1].
- Unplug the cable from Hue Connect[9].
- Unplug driver[8] cable from Hue Connect[9].
- Remove driver[8] and Hue Connect[9] from base[1].
- Break reflector[5] and remove LED strip[?] from Deco ring[4].
Ensure that electrical components are not damaged during this process.
Note that you will need a screwdriver to complete these steps.
For instructions on how to remove the LED strip, please refer to document
442295215544_L2 Removal and Test Instruction Flex LED Strip.
INSTRUCTION
Warnings
Always make sure the luminaire is detached from the mains socket Always make
sure the DC cable is detached from the power supply Staring at the operating
light source may cause eye injury
a
| Disassemble/dismantle steps
Unscrew 2 screws[16] and remove Plastic sealed housing[2] from base[1]
| Tools needed
screwdriver
---|---|---
b
C
| Unplag terminal block[14] and Water proof plug[15] from Plastic sealed housing[2]
Unscrew 2 screws[12] from base[1]
| ****
screwdriver
d
e
| Unscrew 2 screws[11] from base[1]
Unplag cable from hue connect[9]
| screwdriver
f| Unplag driver[8] cable from hue connect[9]|
g| Remove driver[8] and hue connect[9] from base[1]|
h| Breaking Reflector[5] and remove LED strip[?] from Deco ring[4].The
electrical components are not allowed to be damaged.|
FOR LIGHT SOURCE-LED STRIP REMOVAL PLEASE SEE DOCUMENT
442295215544_L2 Removal and Test lnstuction Flex LED Strip
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>