HIFONICS EB-MIC Wireless Microphone Upgrade Kit Instruction Manual
- June 3, 2024
- HIFONICS
Table of Contents
HIFONICS EB-MIC Wireless Microphone Upgrade Kit
Scope of delivery
- 2 x wireless microphone
- 1 x microphone bag
- 1 x upgrade circuit board 4 x fastening screws*
- 4 x plastic washers*
- 1 x installation guide
- A total of 4 AA batteries are required for the microphones.
each 2 as a spare part
UHF transmission range
823.85 / 863.3 MHz
Purpose of use
This upgrade kit is used to equip a HiFonics EB112A sound sys-tem with a
receiver for wireless microphone operation. To do this, the upgrade board must
be installed inside the housing of the sound system. To do this, follow the
instructions below.
NOTE: The kit is not compatible with other HiFonics EB sound systems.
Disposal
If you have to dispose of the de-vices and accessories, please note that no electronic devices may be disposed of with house-hold waste. Dispose of the device in a suitable recycling facility in accordance with local waste regulations. If necessary, consult your local authority or your dealer.
Safety instructions
- In general, the assembly and installation should be made by a trained and technically skilled specialists.
- If you have any problems with the installation, contact your specialist dealer or the Audio Design Service Department un-der Tel. +49 7253 – 94 65 92 or
by E-Mail to amplifiers@audio-design.de
NOTE: Before you start with the assembly, make sure that the EB112A sound system is switched off and disconnected from the power supply (pull out the power plug).
Assembly
- Carefully remove the green circuit board from the micro-phone bag.
- The parts shown above are required for assembly
- When viewed from the front, remove the right carrying handle with a suitable screwdriver.
- Position one of the plastic washers on the inner baffle above the horn’s magnet.
- Then carefully screw the board and washer to the baffle.
- Then align the circuit board accordingly and secure it with the second screw and washer. Make sure that the screws are not overtightened, but that the circuit board is securely attached.
- Then insert the connector located inside the housing on the circuit board. The two loose cable ends are the antennas for wireless reception. These are placed loosely in the housing and do not require any further fastening.
- Finally, attach the handle to the housing again.
Operation
Unscrew the cover at the bottom of the microphones and then insert the batteries. Turn on the two microphones. After you have also turned on the sound system, the microphones are automatically connected to it. The input sensitivity switch is located below the power button:
- Hi = high output level
- Lo = low output level
The volume of the microphones can be adjusted with the “MIC VOL” control on the EB112A.
References
- Domain Default page
- graphic design | content creation | social media
- Audio Design - The Home Of Car Audio, Navigation And More ...
- HiFonics - Power From the Gods
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>