KOBALT SGY-AIR265 Enclosed Retractable Reel with Poly Hybrid Air Hose Instruction Manual

SGY-AIR265 Enclosed Retractable Reel with Poly Hybrid Air Hose
Instruction Manual

ITEM #5091974
50-ft Enclosed
Retractable Reel with
Poly Hybrid Air Hose
MODEL #SGY-AIR265

PACKAGE CONTENTS

HARDWARE CONTENTS

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product. If you have any questions regarding the product, please call customer service at 888-3KOBALT, 8:00 a.m. – 8:00 p.m., EST, Monday-Sunday. You could also contact us at partsplus@lowes.com.

WA R N I N G

• Improper assembly or operation of this product could result in serious injury or property damage. Read and understand all assembly and operation instructions.
• Never remove side cover while hose is under tension. Serious injury could occur.
• Do not exceed maximum pressure of 300 PSI. Use compressed air regulated to a maximum pressure at or below the rated pressure of any attachments to this product.
• Protect your eyes by wearing safety glasses or a face shield when mounting and using this product.
• Keep loose clothing, hair, and jewelry away from moving parts of hose reel.
• Make sure that the product is firmly mounted before pressurizing.
• Rapidly retracting hose could cause injury and property damage. Maintain control of hose as it retracts.
• Keep hose away from sharp edges. Check hose for wear before each use.

PREPARATION

Before assembling the product, make sure all parts are included. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do  not attempt to assemble the product. Estimated Assembly Time: 10-15 minutes Tools required for assembly and installation (not included):

• 3/8″ (10 mm) Wrench
• Phillips Screwdriver
• Sealant Tape
• Drill & 3/8″ Drill Bit
• Pencil
• Level

ASSEMBLY INSTRUCTIONS

Find a piece paper to make a template of the wall mount bracket (D). Place the paper over the mounting bracket and mark the bolt holes of the bracket. See figure 1.

1. Pick where you would like to hang the hose reel. Tape the template on the wall.

2. Using the 3/8″ drill bit, drill the 3 holes that you marked on the template. See figure 2.
   NOTE:
   If drilling directly into wood then there is no need to use the plastic anchors.
   If drilling into dry wall or cement you will need to insert the plastic anchors into the hole.
   Insert anchors if needed, then screw 2 of the mounting screws into the holes (upper one and the lower one). Leave about 6 mm (1/4-in) between the wall and screw head.

3. Hang the hose reel on the 2 screws you previously installed.

4. Push down on the mounting bracket until the 2 screws slide into the top of the top of the hole in the bracket. See figure 3.

5. Tighten the 2 screws and then insert and tighten the middle screw to finish locking the bracket in place.

6. Pull out the hose to the desired length, ensure the hose reel is locked (will not rewind) open the latch on the bumper (G) and move it to the desired location. Re-latch  the bumper (G). See figure 4.

OPERATING INSTRUCTIONS

1. To extend air hose (B), slowly pull air hose to desired length. The hose reel will make a “clicking” sound as the hose is pulled out. The clicking sound you hear is the  drum locking into place so it will not retract when you let go of the air hose. It may be necessary to pull the air hose beyond desired length to keep it from automatically  retracting.
2. To retract, slowly pull air hose (B) until clicking stops. While holding the air hose, let the hose automatically draw back until the bumper (I) stops against the hose guide (H).
   NOTE To avoid damaging the hose reel (A), always hold on to air hose (B) while it is rewinding.

CARE AND MAINTENANCE

Always operate the product with care by following the operating instructions.

TROUBLESHOOTING

If you have any questions regarding the product, please call customer service at 888-3KOBALT, 8:00 a.m. – 8:00 p.m. EST, Monday-Sunday. You could also contact us at  partsplus@lowes.com.

length hose out, and hold the hose while it is retracting.
The hose becomes tangled and will  not retract.

WARRANTY
This tool is warranted by the manufacturer to the original purchaser from the original purchase date for one (1) year subject to the warranty coverage described herein.
This tool is warranted to the original user to be free from defects in material and workmanship. If you believe that a tool is defective, return the tool, with proper proof of  purchase to the point of purchase. If it is determined that the tool is defective and covered by this warranty, the distributor will replace the tool or refund the purchase price.
This warranty is void if: defects in materials or workmanship or damages result from repairs or alterations which have been made or attempted by others or the unauthorized  use of nonconforming parts; the damage is due to normal wear, damage is due to abuse (including overloading of the tool beyond capacity), improper maintenance, neglect or  accident; or the damage is due to the use of the tool after partial failure or use with improper accessories or unauthorized repair or alteration.
This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
For warranty questions, call our customer service department at 888-3KOBALT, 8:00 a.m. – 8:00 p.m. EST, Monday-Sunday. You could also contact us at partsplus@lowes.com.

REPLACEMENT PARTS LIST

Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 888-3KOBALT, 8:00 a.m. – 8:00 p.m.,
EST, Monday-Sunday. You could also contact us at partsplus@lowes.com.
KOBALT and logo design are trademarks
or registered trademarks of LF, LLC.
All rights reserved.SS22247

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>