Powerbeats Pro Wireless Earbuds Bluetooth Headphones Instructions
- June 9, 2024
- PowerBeats
Table of Contents
Wireless Earbuds Bluetooth Headphones
Instructions
Customer Support
Activation & Warranty Permanent replacement of damaged, defective item or
missing components.Please activate via email below within 15 days.
usservicer01@vip.163.com
Packaging List
Product Overview
- Charging port
- Factory recover key
- Magnetic Charging Pin
- Multifunctional Button
- Earbud led
- Volume down
- Volume up
Power On & Pairing
Approach 1 – With Charging Case
Take out earphones from the charging case Select “R8 “from Bluetooth list
Approach 2- Without Charging Case
Power On: Touch the earphones for 2 seconds Prompt sound ‘Power on’
Pairing: Right earphone White light flash Select “R8”
Note: Right earphone is the master earphone
Incoming call
Answer call/End call
Tap the Left / Right earphone once
Reject call
Touch the Left / Right earphone for 2 seconds
Music
Pause/Play
Tap the Left / Right earphone once
Voice Assistant
Tap the Left / Right earphone 3 times
Change Song
Double-tap the Left/Right earphone
Adjust Volume
Tap”+”/”-” on the left/right earphone once
Power Off
Mode -Without Charging Case
Turn off Bluetooth on phone to disconnect the earphones. Then press either one
earphone for 10 seconds to power off both earphones.
Game Mode
Game Mode On: Tap Left / Right earphones 4 times with prompt sound: Game mode
Game Mode Off: Tap Left / Right earphones 4 times with prompt sound: Game off
Charging
Earphones:
Open and close the charging case cap, wait for 3 seconds.
The leftmost/rightmost LED light on: Left/Right earphone is charging LED light
off: Fully charged
Note: It takes about 1 hour to fully charge the earphones
Charging Case:
Put the earphones back to the case Lights on charging case stand for the
remaining battery capacity
Note: It takes about 1 hour to fully charge the charging case
Safety Instruction
Using earphones at high to moderate volumes for extended periods of time will
result in permanent hearing damage. It is advised that you keep volume levels
moderate to low at alll times for your safety.
Do not use while driving, cycling, operating machinery or performing other
activities that require hearing surrounding sounds.
Do not use earphones in thunderstorm weather, the earphones may not work
properly in the bad weather condition, and may increase the risk of being hit
by lightning.
Earphones may not work properly under high temperature or high humidity
conditions.
Do not use any corrosive cleaner/oil to clean the earphones. If the earphones
come in contact with liquids, quickly wipe away. If submersed in the water, do
not turn the earphones on until it is completely dried.
Tips: Man-made damage and lost are not covered under warranty. Keep the
earphones and the packaging out of reach of children.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC ID
This device complies with Industry Canada Icence-exempt RSS standard(s).
Operation Is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference thatmoy cause undesired operation of the device.
RF warning statoment: The device has been evaluated to meet general RF
exposure requirement The device can be used in portable exposure condition
without restriction.