Aqua Creek Products F-031473EZ Extended Reach Anchor Arm User Manual
- June 9, 2024
- Aqua Creek Products
Table of Contents
Aqua Creek Products F-031473EZ Extended Reach Anchor Arm
Product Information
EZ ANCHOR – EXTENSION – 30.00
The EZ Anchor Extension is a pool lift accessory designed for use with Aqua
Creek pool lifts. It is used to extend the reach of the lift, providing more
flexibility in terms of placement and use. The extension measures 30 inches or
76.20cm in length and comes with a leveling foot for added stability.
LEAVE THIS MANUAL WITH OWNER
Read and follow all instructions. Lift safety can only be ensured if the lift
is installed and operated according to these instructions.
Important Instructions for Usage
- Inspect all parts: Before beginning assembly, check the entire box and all packing materials for parts. Ensure that all parts are present and undamaged.
- Proper installation: Proper installation is critical for lift safety, and an improper installation may void Aqua Creek’s warranty and affect the safety of the user. Read and follow all instructions carefully.
- Confirm setback distance: Insert the EZ Pool Lift into the EZ Extension Anchor, and confirm that the anchor is set back 12 to 38 inches for wall clearance.
- Best use: The extension anchor is designed for best use when the sling seat is in line with the anchor. Always load and unload to and from the sling seat while the sling is in line with the extension anchor.
Product Usage Instructions
To use the EZ Anchor Extension, follow these steps:
- Ensure that the pool lift is properly installed and in good working condition.
- Insert the EZ Pool Lift into the EZ Extension Anchor.
- Confirm that the anchor is set back 12 to 38 inches for wall clearance.
- Ensure that the sling seat is in line with the anchor for best use.
- Load and unload to and from the sling seat while it is in line with the extension anchor.
FOR SAFETY REASONS
- NEVER swim alone
- NEVER use the lift with a dry pool
- NEVER apply direct water pressure to the electronics
- NEVER permit children to play on or around the lift
- DO NOT allow children to use the lift without adult supervision
READ CAREFULLY
- Check entire box and all packing materials for parts. Before beginning assembly, read the instructions and identify parts using the figures and parts listed in this document.
- It is critical that all parts be carefully inspected prior to installation. If any damage occurred in transit, Aqua Creek Products, LLC must be notified within three days of receipt of unit.
- Proper installation cannot be overstressed, as an improper installation voids Aqua Creek’s warranty and may affect the safety of the user.
INSTALLATION
INSERT THE EZ EXTENSION ANCHOR INTO THE EXISTING ANCHOR LOCATION ON THE POOL DECK. THE EXTENSION ANCHOR NEEDS TO BE RUNNING PERPENDICULAR, OR WITHIN TEN (10) DEGREES EITHER WAY, TO THE POOL WALL. THE CENTER OF THE LIFT END OF THE ANCHOR NEEDS TO BE BETWEEN 12″ AND 38″ FROM THE POOL WALL IN ORDER FOR THE LIFT TO CLEAR THE WALL AND PLACE THE OCCUPANT INTO THE WATER. ONCE THE EXTENSION ANCHOR IS IN POSITION, ADJUST THE PRESSURE FOOT DOWN UNTIL IT IS RESTING ON THE DECK AND THE EXTENSION ANCHOR IS LEVEL WITH THE POOL DECK.
INSERT THE EZ POOL LIFT INTO THE EZ EXTENSION ANCHOR. CONFIRM THE ANCHOR IS SETBACK 12″ TO 38″ FOR WALL CLEARANCE. THE EXTENSION ANCHOR IS DESIGNED FOR BEST USE WHEN SLING SEAT IS IN LINE WITH THE ANCHOR. BE SURE TO ALWAYS LOAD AND UNLOAD TO AND FROM THE SLING SEAT WHILE THE SLING IS IN LINE WITH THE EXTENSION ANCHOR. SEE DIAGRAM – LEFT.
AQUACREEK.COM
A MordabE Aquatic Exercise, and Access PLUS Much
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>