SLOAN WETS-2020.1435 Wall Hung Closet Instructions
- June 9, 2024
- SLOAN
Table of Contents
SLOAN WETS-2020.1435 Wall Hung Closet
Product Information
The product is a series of wall hung and floor mount closets offered under the ST-2000 series by Sloan. The wall hung series includes items with top spud or rear spud, bedpan lug, and universal options with various gpf (gallons per flush) ranging from 1.1 to 1.6 gpf for top spud and 1.28 gpf to 1.6 gpf for rear spud. The floor mount series includes items with top spud or rear spud, bedpan lug, and ADA (Americans with Disabilities Act) compliant options with various gpf ranging from 1.1 to 1.6 gpf for top spud and 1.6/1.1 gpf for rear spud. The product is designed for use in commercial or public restrooms.
Product Usage Instructions
- For troubleshooting issues such as water not shutting off in the bowl or a sluggish flush, refer to the Troubleshooting Guide in the user manual or contact Sloan Technical Support at 1-888-SLOAN-14 (1-888-756-2614).
- Do not use harsh or caustic chemicals such as drain opening types in this system as they can damage the vitreous finish.
- Avoid flushing foreign objects such as paper towels, paper cups, sanitary napkins, etc. through the toilet.
- Regularly clean the toilet using personal protection equipment such as gloves and eyewear. Refer to the Care and Cleaning section in the user manual for details.
Wall Hung & Floor Mount Closet Series
Wall Hung Closet Series
Floor Mount Closet Series
TROUBLESHOOTING GUIDE
- Water does not shut off in bowl.
- A. Malfunctioning flushometer. Contact Sloan Technical Support at 1-888-SLOAN-14 (1-888-756-2614).
- B. Supply pressure too low. Minimum flowing pressure must be 25 PSI. Adjust supply pressure.
- Water is leaking from toilet.
- A. Toilet is not properly mounted. Tighten toilet mount nuts.
- B. Toilet is not properly mounted. Replace gasket seal.
- Toilet emits odor.
- A. Plugged vent line. Remove or clear obstruction in vent line.
- Poor or sluggish flush.
- A. Supply pressure too low. Water supply must be able to provide 18 gpm at 25 psi.
- B. Partially clogged trapway and/or drain pipe and/or vent. Remove or clear obstruction in vent line.
IMPORTANT INFORMATION
- Do not use harsh or caustic chemicals such as drain opening types in this system. These products will damage the vitreous finish.
- Do not permit foreign objects (i.e., paper towels, paper cups, sanitary napkins, etc.) to be flushed through the toilet.
- The toilet must be regularly cleaned. See CARE AND CLEANING for details.
CARE AND CLEANING
Sloan’s toilets should be cleaned regularly for maximum sanitary and operational performance. As with any plumbing product consistency is important to achieve efficiency and general cleanliness. Before you begin to clean a toilet, gather all the needed materials including personal protection equipment, such as gloves and eyewear.
What You’ll Need:
- Goggles/safety glasses
- Toilet Brush
- Gloves
- Cleanser for inside the bowl
- Cleanser for outside the bowl
- Paper towels or cloth
Inside Toilet Bowl:
Add your choice of powder, liquid or gel cleanser to the bowl*. Try to apply
the cleaner as close to the toilet rim as possible to prevent diluted
cleanser. Begin cleaning the bowl from the top down. Always begin scrubbing
under the rim first. Look under the rim to get all the stains and grime
scrubbed away. Next scrub the bowl. Finally scrub the drain at the bottom of
the bowl. Flush the toilet.
Outside Toilet:
Using a disinfectant/detergent cleaner, mixed either in a spray bottle or in a
bucket (according to label instructions), spray or wipe down all the hard
surfaces outside of the bowl paying close attention to high touch areas like
the toilet seat and flushometer.
NOTE: DO NOT use abrasive or chemical cleaners (including chlorine) to
clean flushometers that may dull the luster and attack the chrome or special
decorative finishes. Use ONLY mild soap and water, then wipe dry with a clean
towel or cloth. If cleaning the fixture with an abrasive or chemical cleaner
protect the flushometer from any splattering of cleaner. Acids and cleaning
fluids will discolor or remove the finish. The toilet seat should never be
neglected. It is the part of the toilet that comes into actual contact with
people, and it needs to be cleaned thoroughly. Raise the seat. Spray the seat,
inside lid (if applicable) and the rim of the toilet with cleanser. Wipe down
the lid, seat and hinges at the back of the toilet seat.
Wipe Up Spills:
Wipe up any spills that may have splashed or occurred during cleaning.
Service Tip:
Checking for water leaks around toilet fixtures can be difficult to locate the
source. Place paper towels around suspected area. It is best to start at the
top of the fixture since gravity will cause the water leak to run downward.
When assistance is required, please contact Sloan Technical Support at:
1-888-SLOAN-14 (1-888-756-2614).
*Consult your local janitorial supply to advise best cleansers to use for local water types. Always use cleaners according to their instructions.
Pressure-Assisted Toilets
Water Closet Model| Bowl Code| Tank Code| | Rim|
GPF
---|---|---|---|---|---
WETS-8009.8016| | 2108016| LH
}RH
| Standard| 1.0 gpf/3.8 Lpf
WETS-8009.8010| | 2108010| 1.28 gpf/4.8 Lpf
WETS-8009.8013| 2108009| 2108013| 1.6 gpf/6.0 Lpf
WETS-8009.8116| 2108116| 1.0 gpf/3.8 Lpf
WETS-8009.8110| | 2108110| 1.28 gpf/4.8 Lpf
WETS-8009.8113| | 2108113| 1.6 gpf/6.0 Lpf
WETS-8029.8016 WETS-8029.8010| | 2108016
2108010
| LH| | 1.0 gpf/3.8 Lpf
1.28 gpf/4.8 Lpf
WETS-8029.8013| 2108029| 2108013| }RH| ADA| 1.6 gpf/6.0 Lpf
WETS-8029.8116 WETS-8029.8110| 2108116
2108110
| 1.0 gpf/3.8 Lpf
1.28 gpf/4.8 Lpf
WETS-8029.8113| | 2108113| | | 1.6 gpf/6.0 Lpf
TROUBLESHOOTING GUIDE
- Poor Flush.
- A. Check the overall height of the lever in comparison to the frame, and adjust if required.
- B. Make sure water supply valve is fully open.
- C. Flush the supply line to clear any debris and clean inlet screen.
- D. Check bowl (main jet, rim holes and trapway), drain line, and vent for blockage.
- E. Check water pressure supply, operating range is 20-80 PSI (503 Series), 25-80 PSI (504 Series).
- Pressure vessel takes a long time to fill.
- A. Make sure water supply valve is fully open.
- B. Flush the supply line to clear any debris and clean inlet screen.
- C. Check water pressure supply, operating range is 20-80 PSI (503 Series), 25-80 PSI (504 Series).
- Noisy pressure vessel water refill.
- A. Flush the supply line to clear any debris and clean inlet screen.
- B. Flush the toilet and hold the handle down for 30 to 40 seconds to flush the system.
- Water continues to flow through the vessel and will not refill.
- A. Check the overall height of the lever in comparison to the frame, the cable connection to the frame and lever, and adjust if required.
- B. Make sure water supply valve is fully open.
- C. Flush the supply line to clear any debris and clean inlet screen.
- D. Check cartridge and adjust if required.
- Handle does not activate flush.
- A. Check the cable cassette connection to handle the cable connection to the frame and lever, and adjust if required.
- B. Make sure water supply valve is fully open.
- C. Flush the supply line to clear any debris and clean inlet screen.
- If the water rises in bowl during the flush and stays there, or drains slowly.
- A. Check bowl (main jet, rim holes and trapway), drain line, and vent for blockage.
- Leaking tanks.
- A. Check the tank-to-bowl gasket to ensure it is aligned properly and tighten the tank bolts.
- B. Check tank for cracks. If cracked the tank must be replaced.
- C. Check tank bolts. Rubber washers may be corroded or bolts may be loose. Replace or tighten as necessary.
NOTE: be careful not to overtighten nuts on tank as this may result in
cracking the tank.
NOTE: It is normal to have some residual water (less than 1”) inside the
tank. The vessel is equipped with a drain valve to drain off excess water.
Cleaning & Maintenance
Clean water closet at least once per week with a cleaner safe for vitreous
china. Spray and wipe clean using soft cloth. Soft abrasive cleaners may be
used to remove stains If you live in a hard water area, you should make
certain that the holes under the rim are kept clean and free of mineral build
up for proper bowl performance. Use a long-handled brush to clean the rim
holes.
Make sure to periodically clean the in-line filter located in the water inlet
of the water supply valve.
CAUTION: Do not use any in-tank cleaners or deodorizers. Products
containing chlorine (calcium hypochlorite) can seriously damage the Flushmate
as well as the fittings in your tank. This damage can cause leakage and
property damage. For more complete up-to date information please visit us at
www.sloan.com. If further assistance is required, If you should still have
trouble contact Sloan Technical Support at: 1-888- SLOAN-14
(1-888-756-2614)
OTHER SERIES
Washdown Urinal Series
Retrofit Urinal Series
Small Urinal Series
Documents / Resources
|
SLOAN WETS-2020.1435 Wall Hung
Closet
[pdf] Instructions
ST-2063-A, ST-2459, ST-2459-BPL, ST-2469, ST-2009, ST-2010-A, ST-2012-A,
ST-2013-A, ST-2019, ST-2029, ST-2029-A-BPL, ST-2039, ST-2030-A, ST-2032-A,
ST-2033-A, ST-2229, ST-2449, WETS-2020.1435 Wall Hung Closet, WETS-2020.1435,
Wall Hung Closet, Hung Closet, Closet
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>