RENPHO RP-ALM070H Leg Massager with Heat for Circulation User Guide

RENPHO RP-ALM070H Leg Massager with Heat for Circulation

Thank you for your purchase of the RENPHO Leg Massager. This Leg Massager is designed to massage your feet, calves, and thighs. It helps to relieve muscle pain and fatigue. You should use it with care and safety in mind. To ensure safety and avoid any property damage, please read this manual carefully and use it as indicated. Non-compliance may cause serious injuries or death and/or severe property damage.

Important Safety Instructions

1. If any of the following apply to you, please consult a doctor before use: Pregnant women, children, or the elderly
   • People who suffer from skin infections or have redness and burns on the skin
   • People who use a pacemaker or similar implantable medical device
   • Patients with heart disease or malignant tumors
   • People who are receiving medical treatment or feel discomfort
   • People suffering from osteoporosis
   • People with high blood pressure or abnormal blood pressure
2. This product should not be used for any medical purposes. It is designed for personal and non-professional use only.

About the Renpho Leg Massager with Heat

What’s in the box

• 1 Pair of calf & foot wraps
• 1 Pair of thigh wraps
• Handheld controller
• Power adapter
• User manual
• Storage bag

Product Introduction

Using the Leg Massager with Heat

Important tips before use

1. When wearing the wraps, please ensure the corresponding wraps for the Left and Right legs. There is a round sticker on the hose interface marked “R” and “L”, please match the right color and legs to make sure it the normal use. Please connect the hose correctly refer to the below picture.
   

2. Find the marks on the thighs wrap, it shows which side is UP. Please refer to the below picture.
   

3. Make sure all of the hoses have been attached securely and color matched.

4. If you feel powerful or uncomfortable, here are some solutions for your better reference.

5. Choose the lowest intensity

6. Open the Velcro of the corresponding part

7. Press the POWER button to turn off

8. Disconnect the corresponding air hose, and the airbag of the corresponding part will quickly deflate

9. It is recommended to leave a gap available to put 4 fingers in it or choose the lowest intensity if you feel powerful

10. The length of air hose can be adjustable according to your need. Please check the below picture.
    

11. The temperature rise of the handheld control is normal.

Operation Instruction

1. When connecting the power adapter, The indicator light of the intensity and heat will be SOLID RED when it is powered on successfully.

2. “ ” Power On/Off Button. Press to turn on/off the massager. The default mode is to combine massage mode 1 with air intensity M. and high heat level(SOLID RED).

3. “ ” Combine Massage Modes. Press to select from the 3 com­bine massage modes.
   Combine 1: Massage full legs.
   Combine 2: Massage feet and calves. (It can be used individually, and don’t need to connect the air hose of thigh wraps.)
   Combine 3: Massage feet, calves, and thighs by turn. It will turn off when you press Button C again.

4. “ ” Separate Massage Modes. Press to select from the thigh, calf, and foot separately.
   T: Massages thighs
   C: Massages calves
   F: Massages feet. It will turn off when you press the Button S again.

5. “ ” Heat Button: Press to adjust the heat levels(low and high temperature), the default heat level is high temperature. BLIN­KING RED indicates the low temperature (109° F), and SOLID RED indicates the high temperature(118° F). You can press this button to turn off it.
   Heating area: calves and feet.
   Note:

6. The massager will be auto shut off every 20 minutes. And before auto shut off, the indicator light of the corresponding mode will be BLINKING RED. Press the power button again to re-run the massager. It’s recommended to use it once or twice daily.

7. The massager comes with a memory design without power cut off, so it automatically operates the last running mode and intensity when powering on.

8. If you choose one of these functions like combine mode or separate mode or heat, you can turn off it by pressing the button C, Under this situation, when you press the power button, it doesn’t come with a memory function, the default mode is C 1 with air intensity M and high heat level (SOLID RED)

9. “ “Air Intensity Button. Press to reduce or enhance the intens­ity. There are 3 intensity levels for each mode, the default intensity is level M. It is recommended to leave a gap available to put 4 fingers in it or choose the lowest intensity if you feel powerful.

10. You can choose to massage only one leg at one time, make sure that all of the hoses connect to the boots and that the color matches both the right and left boot. Then only wear the left or right boot.

Safety & Maintenance

1. Do not use spare parts that are not approved by the manufacturer.
   • Non-professional repair personnel should not dismantle or replace the parts of the leg massager without permission.
   • If the power cord is damaged, it must be replaced by the related professional personnel in order to avoid danger.
   • Do not use or store the product in a place with humidity or high temperature.
   • Unplug the power cord after use.
   • Stop using it immediately if any adverse reactions occur.
   • Stop using it immediately and cut off the power if the product becomes extremely hot or the product begins to smell or emit an odor.
   • Do not move the product by pulling the power cord.
2. This product should not be used by those who are deficient in physical, sensory, or Controller mental abilities (possibly including children).
3. Cleaning Method
   • Do not wash, or machine wash, it’s recommended to wipe the massager with a soft, damp, or dry cloth.
4. Packing Method
   Please avoid folding the tube when packing, or it may cause inflation failure.

Troubleshooting

The product does not work

|

The power is not connected or the plug is loose

|

Plug in the power cord correctly(The indicator light will be red after pressing the power button)

The power switch is not on or the auto-shut-off timer turns it off|

Turn on the power switch

Some parts can’t inflate

|

The color of the hose doesn’t match

| Please follow the instructions according to “Important tips before use” to match and connect the air hose
The current massage mode excludes massage in this part| Please choose the corresponding mode

The tube has not been attached securely, and there are air leaks

| Please check again if the hose is attached securely- ly with the boots. (no gap between hose interface and boot)

The tube has been folded

| 1.  Please avoid folding the tube when packing

2.  Please contact support@renpho.com

Feel powerful

or uncomfortable

|

Wrap your legs too tight

| 1.  Choose the lowest intensity

2.   Open the Velcro of the corresponding part

3.  Press the POWER button to turn off

4.  Disconnect the corresponding air hose, the airbag of the corresponding part will quickly deflate

Maybe use the highest intensity

The product suddenly stops working

| The massager’s over-heat protection feature will switch off the massager automatically when too hot| Wait for the massager to cool down before powering it back on

20 minutes timer turns it off

|

Press the power button again

The handheld controller gets hot

|

The product has been used continuously for a long time(The temperature rise of the handheld control is normal.)

| Recommended to use 20 minutes to 30 minutes to avoid OVERUSE. After turning it off, allow the massager to cool down before using it again
PROBLEM| CAUSE| SOLUTION
---|---|---

Feel the difference of intensity when massaging two legs at the same time

| Some tube has not been attached securely or attached to the wrong hose|

Please make sure the tube is attached securely

When wearing the boots, the gap you leave may be different

|

Please leave the same gap when you wear it

Can’t feel the heartbeat tune- it is weak

| Maybe choose the low temperature| Please choose the high temperature
Maybe use it for just 1-2 minutes| Please use it for about 4-6 minutes
If you encounter any other problems, contact: support@renpho.com

Specifications

• Product Name: RENPHO Leg Massager With Heat
• Model: RP-ALM070H
• Product: Input: 12V=-=2A
• Rated Power: 24 W
• AC Adapter: Input: AC 100-240V 50/60Hz
• Output: 12V === 2A
• Timer: 20 minutes

Warranty (1-Year)

1. The manufacturer’s warranty is void under the following circu­mstances but not limited to:
   • Improper or inadequate maintenance or modification.
   • Accident, misuse, abuse, contamination, or other external causes.
   • The use of unspecified adapters and accessories.
   • Loss or damage in transit.
   • Damages occur as a result of one’s failure to follow instructions.
2. This warranty does not apply to expendable or consumable parts and does not extend to any product from which the serial number has been removed.

Customer Service

We have an award-winning warranty, exchange, and customer service team that guarantees hassle-free solutions to any issue you might have within 24 hours.

Tel: +1(844)417-0149 (US ONLY) Monday-Friday 9:00 AM – 4:30 PM
Email: support@renpho.com

FCC Statement

This device complies with ICES-003 Rules and US Electronic Code of Federal Regulations 47 CFR FCC Part 15; Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer­ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help with the supplied fastener. DO NOT hang the unit by the power cord.

JOICOM CORPORATION
5984 Archibald Ave. Building 1, Suite 1, Eastvale, CA 92880 Shenzhen Runfeng Digital Technology Co., LTD Chuanghui Building, Intersection of Banxuegang Boulevard and Yongx­iang Road, Bantian Subdistrict, Longgang District, Shenzhen, China

FAQs

What is the difference between the RP-ALM070H and the RP-ALM070T?****

The only difference is that the RP-ALM070H has heat while the RP-ALM070T does not.

What is a leg massager for circulation in the hospital?****

Intermittent pneumatic compression (IPC) devices are inflatable sleeves that you wear on your calves (lower legs). Healthcare providers most often prescribe them while you are in the hospital. The sleeves inflate every 20 to 60 seconds, then deflate. The sensation feels like a leg massage.

How many times a day can you use a leg massager?****

It depends on your health and the health of your leg muscles. If you’re generally fit and free from chronic illnesses, you can use it 3-5 times a week. Some athletes and fitness fans use it on a regular basis without a break.

How long should you use a leg massager?****

It’s often recommended to use an electric foot massager for 15 to 20 minutes per session rather than for prolonged periods of time in a single sitting.

Are leg massagers good for circulation?****

Yes, leg massagers can provide long-term relief from pain and discomfort. Regular use of a leg massager can help to improve circulation, which in turn can reduce inflammation and swelling in the legs. Additionally, it may help reduce muscle tension, leading to improved mobility and flexibility.

How often should you use the compression leg massager?****

You can use the leg compression massager for circulation every day, or whenever you need it to improve blood flow.

Is a leg massager good for your health?****

This will help reduce inflammation or swelling and, in turn, muscle stress or pain in the feet and calves.

What is the use of a leg massager?****

Leg massagers are designed in a way that they work on relaxing your muscles in a few minutes. So, if you are tired after a long day or you are having muscular pain, you will feel better after using a leg massager.

Do leg massagers help with pain?****

A leg massage can relieve sore, tired muscles. The benefits vary depending on how much pressure you apply. Using light pressure can be more relaxing. Strong pressure reduces tension and pain in your muscles.

Will a leg massager help prevent blood clots?****

The pump inflates different sections of the sleeves, squeezing from bottom to top in a massaging motion to help move the blood in your legs. The compression and massaging help prevent blood clots. Clots can form in the veins when you are not active for a long period of time.

Video – Product Overview

Download The PDF Link;RENPHO Leg Massager with Heat for Circulation PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>