VISUAL COMFORT 8537401 Barn Light Outdoor Wall 1.0 Instruction Manual
- June 10, 2024
- VISUAL COMFORT
Table of Contents
8537401 Barn Light Outdoor Wall 1.0
Instruction Manual
ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junction
boxes.
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
Install the Fixture
- Secure the mounting plate to the junction box.
- Optional: Feed fixture wires through the arm extension and screw the threaded end of the fixture arm into the fixture.
- Feed the fixture wires into the fixture base.
- Insert the fixture arm into the fixture base and secure in place with the provided alley screws.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Neatly place the wires into the junction box, mount the fixture base onto the mounting plate studs, and secure it with the two cap nuts.
- Screw the lamp into socket. Refer to the label on the socket for Max Wattage Information.
- Caulk around the base of the fixture with waterproof construction sealant.
8537401, 8637401, 8737401, 8837401
CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
This product requires installation by a qualified electrician.
Before installing be sure to read all instructions and Use minimum 90°c supply
conductors.
7400 Linder Ave, Skokie, IL 160077
800.969.3347
www.visualcomfort.com
©2023 Visual Comfort & Co.. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.