Knightsbridge NH016W 1W LED Aluminum Square Recessed Wall Light Instruction Manual

NH016W 1W LED Aluminum Square Recessed Wall Light
**Instruction Manual

INSTALLATION & MAINTENANCE MANUAL
NH016W / NH017W
**

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future reference and maintenance.
These instructions should be used to aid installation of the following products: NH016W / NH017W

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the circuit cable, fuse, or circuit breaker
• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for installation
• This product is Class II double insulated
• This product series is IP44 rated

INSTALLATION

Note – If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods)
• Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to infringe with any joists, gas/water pipes or electrical cables
• Insert the sleeve into the cut-out and ensure that the mains cable is pulled through into the sleeve
• Fix the sleeve to the surface using suitable screws (not provided)
• Remove the terminal cover of the luminaire by unscrewing the three screws
• Feed the mains cable through the gland on the rear of the terminal cover
• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L – Live (brown), N – Neutral (blue)
• Replace the terminal cover
• Tighten the compression gland ensuring a tight seal is made
• Insert the body of the luminaire into the sleeve ensuring that the side blades locate into the slotted holes in the side of the sleeve
• Switch on and check for correct operation

WARNING

This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. This product is not suitable for direct installation in the ground, nor in a retaining wall where the ground may become saturated behind. This product is not suitable for installation in or near a coastal or marine environment.

GENERAL

The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire should be replaced. Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use aggressive cleaning products or solvents which may damage the product. Do not use any source of high-pressure washers to maintain or clean this luminaire. This product is non-dimmable. This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist.

WARRANTY

This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice.

INTERNATIONAL CONTACT DETAIL Shttps://www.mlaccessories.co.uk/contact- us ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
AVSEP21_V1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>