stalgast 430400 Adjustable Electric Heating Module Instruction Manual
- June 10, 2024
- stalgast
Table of Contents
ADJUSTABLE ELECTRIC HEATING MODULE
430400
Instruction manual – Translation of the original manual
430400 Adjustable Electric Heating Module
Thank you for purchasing our product. Please read this manual carefully before
using it for the first time.
In order to provide you with the best technical solutions for your devices, we
are constantly developing them technologically.
Therefore, the pictures and drawings in this manual may differ from the
purchased device.
NOTE: Keep this manual in a safe place that is accessible to personnel.
The manufacturer reserves the right to change technical parameters of the
devices. Copying of this manual without permission of the manufacturer is
prohibited.
SAFETY INSTRUCTIONS
-
Incorrect maintenance and/or use may cause serious harm to people and damage the device.
-
The device can only be used for the purpose for which it has been designed.
-
The manufacturer does not take any responsibility for damages caused by improper maintenance or use of the device.
-
When in use, secure the device and its electrical plug from any contact with water or other fluids. In case the device is accidentally dropped
into water the electrical plug should be immediately removed from the socket and the device should be inspected by a trained professional. Failure to obey these instructions may cause life threatening danger. -
Never open the casing of the device on your own.
-
Do not stick any objects into the casing of the device.
-
Do not touch the electrical plug with wet hands.
-
Check the condition of the electrical plug and cord regularly. In case any damage to the plug or cord is discovered order repair by a specialized service provider.
-
In case the device is dropped or damaged otherwise, before further use always order a check-up and repair by a specialized service provider.
-
Do not make any attempts to repair the device on your own – this may cause life threatening danger.
-
Protect the electrical cord from contact with sharp or hot objects and keep it away from open fire. When you disconnect the device from the electrical socket always hold the plug and never pull the electrical cord.
-
Secure the electrical cord (or the extension cord), so that it is not unplugged by mistake and so that no one can stumble over it.
-
Monitor functioning of the device while in use.
-
Use of the device by people underage, physically or mentally incapable, with motion disorders as well as people without proper experience and knowledge regarding the use of this device should not be allowed. All of the above should only use the device under supervision of a person responsible for their health and safety.
-
When not used or during maintenance you should always unplug the device from the source of electricity by removing the electrical plug from the socket.
-
ATTENTION: when the electrical plug is plugged into the socket the device is constantly live.
-
Switch the device off before removing the plug from the socket.
-
Never pull the device by the electrical cord.
WARNINGS
- Do not use any additional elements other than supplied with the device.
- High Voltage! Unplug the device before cleaning or maintenance
- Keep away from flammable materials.
- Check characteristics of the available source of power before plugging in.
- In case of damage, the power cord must be repaired by a technician at a specialized workshop.
ATTENTION: if the electrical plug is plugged into the socket the device is constantly live.
TECHNICAL SPECIFICATION
Model| Power source (v)| Frequency (hz)| Total generated
power (w)| Dimensions (mm)
---|---|---|---|---
430400| 230| 50| 400| 230×200
SETTING UP THE DEVICE
- Type 1: take the water container off the holder and turn it upside down (step 1). Then slide the heating module into the right place (slides) (step 2).
- Type 2: take the water container off the holder and turn it upside down (step 1). Step 2, place the heating module on the screws. Step 3, tighten the nuts on screws by hand (do not use tools)..
OPERATING THE HEATER
- Fill the container with hot water (50 to 60 C). Remember that the heating module cannot be immersed in water! Check the level of water. The heater cannot be used without water!
- Install the cover
- Connect the heating module to a source of electricity and wait 30 to 40 minutes for the heater to reach proper temperature.
Attention! Never use a heating module without a heater.
CLEANING
- Disconnect the power cord from the source of electricity
- Wait for the heating module to cool down
- Remove the heating module from the heater
- Clean with a damp cloth
Attention! Do not submerge the heater under water or clean it under running water.
TROUBLESHOOTING
MALFUNCTIONS | CAUSES | SOLUTIONS |
---|---|---|
Food items are cooling down and the food is not heated | Water container was | |
filled with cold water | Fill the container with hot water | |
The heater was not warmed up before food was placed in the container | Warm-up |
the device for 30-40 minutes before use
The heater was not installed properly| Check if the heater was installed
properlyi
Significant loss of heat| The lid is open| Check and close the lid if
necessary
DISPOSING OF USED EQUIPMENT
Information for users about the proper principles of disposal of waste electric and electronic equipment.
- Leave the old device in the store where you are buying a new device. Each store has an obligation to take your old equipment free of charge if you buy new equipment of the same type and in the same quantity. The only condition is to deliver the equipment to the store at your own expense.
- Take the used device to a collection point. You will find information about the nearest location on the municipal website or bulletin board of the municipal office.
- Leave the device at the service point. If the repair of the device is uneconomical or impossible for technical reasons, the service is obliged accept the device free of charge.
- Return used equipment without leaving your house. If you don’t have the time or ability to transport your equipment to a collection point, you can use the services of specialized companies.
Remember! Do not dispose of used equipment along with household waste. This could cause high fines.
The symbol of the crossed-out waste bin on the product, its packaging or the instruction manual means that the product should not be disposed of to normal waste bins. The user is obliged to hand over the used equipment to a designated collection point for proper processing.
WARRANTY
The seller shall be liable under the warranty or guarantee.
Damage resulting from the formation of lime scale deposits in the device are
not subject to repair under the warranty.
Warranty exchange does not cover such elements as: light bulbs, rubber
components, heating elements damaged by lime scale, screws and elements
undergoing natural wear, e.g. rubber seals and all kinds of mechanically
damaged elements. Any damage of components resulting from improper use is also
excluded from the warranty. The warranty is automatically voided in the event
of a broken warranty seal or independent repairs.
Talgat Sp. z oxo.
Place Kone sera 9, Budnik O, 03-736 Warszawa
tel.: 22 517 15 75 fax: 22 517 15 77
www.stalgast.com
email: stalgast@stalgast.com
Tel.: +48 22 509 30 77
export@stalgast.com
www.stalgast.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>