stalgast 430350 Chafer Heater Instruction Manual

stalgast 430350 Chafer Heater

Thank you for the purchase of our product. Please read this manual carefully before starting to operate the appliance. All rights reserved. No part of this manual may be reproduced by photocopy, printing or in any other way without prior consent from the manufacturer. Photographs and drawings are furnished by way of example and can vary from the purchased appliance. NOTE: Keep the manual in a safe place accessible for the personnel.The manufacturer reserves the right to change technical parameters of the appliance at any time without advance notice.

SAFETY INSTRUCTIONS

• Improper operation and misuse may cause serious damage to the unit or injury to persons.
• The device must only be used for the purpose for which it was designed.
•  The manufacturer is not responsible for any damage caused by improper handling or misuse of the device.
• During use, protect the device and the power cord plug from contact with water or other liquids. If the appliance accidentally falls into water, unplug it from the water outlet immediately and have the appliance checked by a specialist.

Failure to follow these instructions could result in life-threatening injuries.

• Never open the housing of the device yourself.
• Do not insert any objects into the housing of the unit.
• Do not touch the power cord plug with wet hands.
• Regularly check the condition of the plug and the cable. If you find any damage to the plug or the cable, have it repaired by a specialized repair shop.
• If the device falls or is otherwise damaged, always have it inspected and possibly repaired at a specialized repair facility before further use.
• Never repair the unit yourself – doing so may endanger your life.
• Protect the power cord from contact with sharp or hot objects and keep it away from open flames. If you want to disconnect the device from a contact, always grasp the plug, never pull on the cable.
• Secure the cable (or extension cord) so that no one mistakenly pulls it out of contact or trips over it.
• Check the functioning of the device during use.
• Do not allow minors, persons with physical or mental impairments, persons with reduced mobility, or persons without suf-ficient experience and knowledge to operate this device properly. These persons may only operate the device under the supervision of a person responsible for safety.
• If the appliance is not currently in use or is being cleaned, always unplug it from the power source by pulling the plug.

Note : If the power cord plug is connected to a contact, the device remains live at all times.

• Turn the appliance off before you pull the plug out of the socket.
• Never pull the unit by the power cord.

WARNINGS

• Do not use any additional means other than those supplied with the unit.
• High voltage! Disconnect the unit from the power supply before repairing or cleaning.
• Keep away from flammable objects.
• Check the local voltage before starting.
• If damaged, the power cord must be repaired or replaced by a professional at a repair service. ATTENTION! If the power plug is connected to a power outlet, the device is under voltage at all times.

TECHNICAL SPECIFICATIONS

Model| Voltage (V)| Frequency (Hz)| Power (W)| Dimensions (mm)
---|---|---|---|---
430350| 230| 50| 350| 110x160x115

PURPOSE

• alternative to standard paste or gel warmers
• for flat-bottomed water heaters not adapted for installation of electric heaters

CONSTRUCTION

INSTALLATION

1. Place the heater as shown in Figure 2.
   • Easy adjustment to most heaters, made possible by a spring-loaded head.
   • Before placing the heater, wipe the heating surface, with a clean and dry cloth.

HEATER OPERATION

CAUTION: NEVER OPERATE THE HEATER WHEN IT IS EMPTY.

1. Fill the outer container with warm water. The water level should be such that the bottom of the inserted inner container is slightly submerged in the water.
2. Place the inner container with the warm food into the outer container.
3. Cover the whole thing with a lid.
4. connect the heater to the socket

CAUTION! Never use a heater that is not installed in the heater.

CLEANING

1. Disconnect the power cord from the power supply.
2. Wait until the heater and the heater have cooled down.
3.  Remove the heater from the heater, using the handle.
4. Clean with a damp cloth.

CAUTION: Do not immerse the heater in water or pour water over it.

FAILURES, CAUSES, SOLUTIONS

The food cools down and is notheated

| The water vessel has been filled with cold water| Fill the vessel with hot water
Heater was heated too briefly or not heated at all before putting foodin|

Preheat the unit for 30-40minutes

The heater has not been installed correctly| Check the correct position of theheater
The heater has not been plugged in| Connect the heater correctly
High heat loss| The cover is open| Check the cover and close it if necessary

DISPOSAL OF USED EQUIPMENT

Information for users on the proper principles of proceeding with waste electrical and electronic equipment

• Leave your old equipment at the store where you buy new equipment. Every store is obligated to take back old equip-ment free of charge if we buy new equipment of the same type and in the same quantity. The condition is that you bring the equipment to the store at your ownexpense.
• Bring your used equipment to a collection point. Information about the nearest location can be found on the municipal website or the notice board of the municipal office, and alsoatwww.electro-system.pl.
• Leave the equipment at the service point. If it is technically impossible or uneconomical to repair the equipment, the servi-ce centre is obliged to accept it free ofcharge.
• Return used equipment without moving from home. If you do not have the time or ability to take your equipment toa collection point, you can use the services of specialized companies.
• Remember! Do not dispose of used equipment together with other waste. You may be subjected to heavy fines for this.

The crossed-out wheeled garbage can symbol on the product, its packaging or instructions means that the product must not be disposed of with the normal waste containers. It is the user’s responsibility to take theused equipment to a designated collection point for propertreatment.

WARRANTY

The seller is liable under warranty or guarantee. In the case of damage resulting from calcium deposits in the device, they are not subject to warranty repair. The warranty also does not cover damage caused by external forces, such as lightning, change of power voltage, incorrect voltagesetting, power supply from an inappropriate power socket, mechanical, thermal and chemical damage to the equipment and defects caused by them. The warranty does not cover such elements as: light bulbs, rubber elements, heating elements damaged by boiler caustic, screws and elements subject to natural wear, e.g. burners, rubber seals and all kinds of elements damaged mechanically.

Stalgast Sp. z o.o.
Plac Konesera 9, Budynek O, 03-736 Warszawa
tel.: 22 517 15 75 www.stalgast.com
fax: 22 517 15 77
email: stalgast@stalgast.com

Tel.: +48 22 509 30 77 export@stalgast.com www.stalgast.eu

References

• ELECTRO – SYSTEM S.A. Organizacja Odzysku SEiE
• ELECTRO – SYSTEM S.A. Organizacja Odzysku SEiE
• ELECTRO – SYSTEM S.A. Organizacja Odzysku SEiE
• Stalgast | Professional catering equipment | Poland

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>