ARADA M Series Wood Burning Stove User Guide
- June 10, 2024
- ARADA
Table of Contents
M Series Wood Burning Stove
Direct Air Kit Fitting Guide
Optional Accessory Instructions
M Series Wood Burning Stove
PLEASE NOTE: Image shows Ecoburn S3, however procedure is the same
regardless of appliance model.
Applicable Part Numbers — LOG-xxx
STAND-xxx
FEET-xxx
( NOTE: xxx-Model insignia)
Applicable for the following appliances : Holborn, Ecoburn S3 & M-Series
WARNING: HEALTH & SAFETY
Please ensure the appliance is cold and unlit before commencing fitting this
accessory kit.
Please refer to the main instruction booklet, relevant to your stove, for
guidance on the installation and operation of the appliance.
Arada Ltd will not be responsible for any consequential or incidental loss or
injury however caused.
Please note, this accessory kit can only be fitted prior to the appliance
(stove) being installed and connected to the flue system, within the property.
Please consult Health & Safety guidelines for advice on handling heavy and /
or large items. When lifting, we recommend you always obtain assistance.
When handling the components of the kit, it is recommended to wear suitable
gloves to prevent hand injuries.
Fitting Instructions:
Depending upon your appliance model, your stove may have been factory fitted
with the standard foot assembly, however if so desired, this can be removed
and an optional stand or log store can be fitted, so that the appliance height
can be raised.
STEP 1: (NOT Applicable To M-Series)
To remove the factory fitted feet assembly, it is suggested that the canopy
assembly be removed to avoid damage. Carefully lower the stove onto its rear,
taking care not to damage the rear air box and tertiary air inlet cover. We
recommend lowering the stove onto the packing pallet that it was delivered on,
as shown below.
STEP 2:
With the stove safely resting on its back, place a wooden block or similar
suitable packing object to prevent the appliance from rocking or moving, this
can be seen in the image below. Ensure the appliance is secure before
progressing onto step 3.
STEP 3:
Proceed to remove the 4 off fixings; 2 no. are located in either front corners
and the remaining screws are located either side, at the rear of the stove.
Remove the factory fitted feet assembly. Keep this item safe, for future
use.
STEP 4:
Position either the log store or stand assembly, against the appliance base.
Affix the 4 off fixing screws, that were removed in step 3.
Only hand tighten these fixings, otherwise damage to the threads may
occur.
CAUTION:
Only tighten fixings by hand
STEP 5:
Taking care, return the appliance and accessory to the upright position.
Extra caution will be needed as the centre of gravity will have moved by
fitting this new accessory. 
CAUTION:
TAKE CARE WHEN LIFTING UPRIGHT
PLEASE RETAIN THIS GUIDE FOR FUTURE REFERENCE
EN13240:2011 +A2:2004
BK 748 Rev 02
ISSUE DATE: 16/01/2023
Arada Ltd, The Fireworks, Weycroft Avenue, Axminster,
Devon, United Kingdom, EX13 5HU
Technical Help : +44 (0)1297 632052,
www.aradastoves.com
Date Of Issue : 16/01/2023
BK 748 Rev 02
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>