HYUNDAI 68509 Wifi Industrial Construction Dryer User Manual

HYUNDAI 68509 Wifi Industrial Construction Dryer User Manual

WIFI INDUSTRIAL DEHUMIDIFIER 68509

WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
The following symbols are used throughout this manual:

⚠ Denotes risk of personal injury or damage to the machine.
Important information about the use of the machine.

IMPORTANT
You will find the following symbols on the appliance and/or in this manual:

SAFETY REGULATIONS

• The appliance must be installed, operated and stored in a dry room with a floor area of at least 11 m2.
• Never use the appliance in an airtight room. Provide adequate ventilation to prevent under pressure in the room. Under pressure can disrupt safe operation.
• Place the appliance on a solid and flat surface.
• Always move the appliance with both hands.
• Never touch the appliance with damp or wet hands.
• Keep the appliance out of the reach of children and animals.
• The appliance must be stored in a dry room without permanent ignition sources (such as: open fire, a gas appliance or an electric heater)
• Never pierce or incinerate the appliance.
• Never immerse the appliance, cord or plug in water.
• Make sure the air inlet and outlet are not blocked by dirt or objects.
• Do not place any clothing or objects on the appliance.
• Be aware that refrigerants do not have any odour.
• Only install this appliance if it complies with local standards, laws and regulations.
• Do not use an extension cord, have a grounded outlet installed by a qualified electrician.

SAFETY INSTRUCTIONS FOR APPLIANCES WITH R290 REFRIGERANT
(EG) 842/2006 This appliance contains R290 refrigerant. R290 is a refrigerant gas that complies with European environmental directives. The quantity is less than 1 kg (see rating plate for exact quantity) and is in a closed circuit. The coolant has no ozone depleting capacity. However, it is a greenhouse gas under the Kyoto protocol and can thus contribute to global warming when released into the atmosphere. Only trained technicians with an appropriate refrigerant certificate are allowed to fill or empty the appliance. Your appliance must not be topped up with refrigerant if it is used correctly and with an undamaged refrigerant circuit. GWP: R290:

• Do not pierce any part of the refrigeration circuit.
• When defrosting and cleaning the appliance, use only tools recommended by the manufacturer.
• If the appliance is installed, operated or stored in a non-ventilated area, measures must be taken to prevent fire or explosion due to leaked refrigerant. Make sure that no ignition sources (such as fire, stoves, sparking electrical equipment, lit cigarettes, etc.) are in the same room. · The appliance must be stored in such a way as to prevent mechanical defects.
• Persons working or operating the refrigeration circuit must have the appropriate certification, issued by an authorized organization, certifying that these persons are authorized to handle refrigerants in accordance with industry specifications.
• Repairs should be made as recommended by the manufacturer. Maintenance and repair requiring the assistance of other trained personnel must be performed under the supervision of a person specialized in the use of flammable refrigerants.

DESCRIPTION (FIG. A)

This industrial dehumidifier is designed for lowering the humidity and keeping warehouses, garages, corridors, washing and changing rooms dry. Also suitable for protecting stored electronic equipment, documents and medicines against moisture, erosion and fungi.

1. Control panel
2. Grip
3. Castor with brake
4. Handle
5. Air outlet
6. Filter
7. Air inlet
8. Water pump outlet
9. Continuous drainage outlet
10. Rubber wheel

Package contents

• Dehumidifier
• Drain hose Ø 5 mm, length 6 m
• Drain hose Ø 21 mm, length 60 cm
• 4 Allen screws (ST6 x 45)
• User manual
• Guarantee and service conditions

ASSEMBLY

Attaching the handle (fig. B)

• Fasten the handle (4) to the housing with the supplied screws.

Installing the filter (fig. C)

• Slide the filter (6) into the filter holder on the side of the appliance.

FUNCTION

This dehumidifier works by means of condensation to automatically dehumidify rooms. The fan sucks in moist air through the air filter and blows it through an evaporator. The moist air is strongly cooled in the evaporator, causing the water vapor present in the air to precipitate as condensation. This condensation water is collected in a water reservoir and discharged through a hose by means of the built-in water pump. The dehumidified cooled air is passed through a condenser where the air is heated. This heated dry air is blown back into the room, reducing the humidity in the room.

FOR USE

Placement of the appliance
For easy movement, the appliance is equipped with transport and castor wheels.

• Place the appliance on a firm and flat surface.
• Keep at least 50 cm away from a wall or object on all sides.
• Make sure that both the air inlet and the air outlet are not blocked.
• Lock the castors by pressing the brake down.
• After installation, let the appliance stand for at least 24 hours before turning it on.

OPERATION (FIG. D)

ℹ The appliance can be operated in 2 ways: on the control panel and via the Smart Life app.

Operation with the Smart Life app

Download and install the app according to the supplied manual.

Activate WiFi mode

• Switch on the appliance and press FAN (15) for 3 seconds to activate the WiFi mode. The WiFi symbol (18) lights up and flashes quickly.
• Open the app and follow the on-screen instructions to control the appliance with the app.
• Press and hold FAN for 3 seconds to disconnect the Wi-Fi connection.

Control panel

• 11. On/Off button
• 12. Function key
• 13. Turns the child lock function on or off
• 14. Timer key
• 15. Controls the fan speed
• 16. Increases humidity
• 17. Lowers humidity
• 18. WIFI indicator
• 19. Temperature and humidity display
• 20. Time display
• 21. Humidity display
• 22. Automatic dehumidification function
• 23. Continuous dehumidification
• 24. Timer function
• 25. Child lock is activated
• 26. Drain pump failure
• 27. High fan speed
• 28. Low fan speed
• 29. Drain pump activated
• 30. Defrost function activated

USE (FIG. D)

The timer button (14) can be used to set the automatic switch-on and switch- off time from 0 to 24 hours.

Switch on

1. Plug it into the socket.
2. Switch on the appliance with the on/off button (11).

Switch off

1. Switch off the appliance with the on/off button (11).
2. Wait for the pump to stop and remove the plug from the socket

The pump continues to run for a few minutes to drain the rest of the water and then switches off automatically.

⚠ Do not switch off the appliance by pulling the plug from the socket, but always use the on/off button to switch off the appliance and then remove the plug from the socket. Do not move the unit until 3 minutes after it has been turned off to avoid leakage.

Auto power off
While the appliance is running, press the timer button (14) to open the timer setting. Each time the button is pressed, the set time increases by 1 hour. After more than 24 hours, the number returns to 0 and the cycle starts again. If the timer button is not pressed within 5 seconds, it means that the time has been set. Once the set time has elapsed, the appliance will turn off automatically.

Auto power on
In the standby mode of the appliance, press the timer button (14) to open the timer setting. Each time the button is pressed, the set time increases by 1 hour. After more than 24 hours, the number returns to 0 and the cycle starts again. If the timer button is not pressed within 5 seconds, it means that the time has been set. Once the set time has elapsed, the appliance will turn on automatically.

Setting the humidity
The desired humidity can be set with buttons 16 and 17.

Automatic dehumidification
Activate automatic dehumidification with the function key (12). The symbol (22) lights up. If the humidity in the room is 5% higher than the set humidity, the compressor will start and the fan will run at the set air speed. If the humidity in the room is 5% lower than the set humidity, the compressor will stop and the fan will continue to run at the selected speed. If the room humidity is between +5% and -5% of the set humidity, the whole appliance will work in the initial operating state. The initial humidity value is set to 50% relative humidity by default.

Permanent dehumidification
Activate the permanent dehumidification function with the function key (12). The symbol (23) lights up. The compressor starts regardless of the relative humidity in the room, the fan runs at the highest speed as standard and can be adjusted.

Automatic defrost
ℹ At low temperatures, frost may form on the evaporator during use. The appliance starts defrosting automatically and the defrost indicator (30) lights up.

After defrosting, the dehumidification is switched on again.

Child lock function

Connect the drain hose before starting the unit.
With continuous drain The water can be collected in a suitable container.

The child lock function locks all keys on the control panel. The symbol (25) lights up.

• Press and hold the function key (12) presses for 3 sec. to turn the key lock on or off.

DRAIN WATER (FIG. A + D)

The water can be drained in two ways: with the built-in drain pump as soon as the water tank in the appliance fills up or with a continuous drain. Two drain hoses are supplied for this.

With the drain pump
Thanks to the built-in drain pump, the water can be drained over a great distance (max. 6 m) and up to a height of 5 m. The pump starts automatically when the reservoir in the appliance fills up, the drain pump symbol (29) lights up. The pump switches off automatically (the symbol goes out) when the water tank is empty.

⚠ Never use both drain hoses at the same time.

1. Remove the water plug from the outlet of the drain pump (8).
2. Check that the outlet is not clogged.
3. Insert the long drain hose into the connection of the pump (8) (access is possible at any angle).
4. Route the drain hose to a suitable container or outside. The hose can be raised up to 5 m.

Connect the drain hose before starting the unit.

With continuous drain
The water can be collected in a suitable container.

Connect the drain hose before starting the unit and only remove the hose after the appliance has been switched off to prevent residual water from being sprayed out.

1. Remove the water plug from the outlet of the permanent drain (9).
2. Check that the outlet is not clogged.
3. Attach the short drain hose to the outlet.
4. Route the drain hose to a suitable container or drain.

⚠ The end of the hose must be at least 10 cm lower than the outlet on the appliance. The hose must be smooth and not kinked. Make sure that the hose cannot get into the collected water, otherwise the water will not drain properly.

CLEANING AND MAINTENANCE

ℹ Regular cleaning is important for a long life of the appliance!

⚠ Before carrying out cleaning and maintenance work, always switch off the appliance and remove the plug from the socket!

Cleaning the air filter (fig. C)
⚠ Dust and dirt collect on the filter, restricting airflow. Restricted airflow reduces optimal operation and can cause damage to the appliance. The air filter should be cleaned every week.

1. Switch off the appliance before cleaning, wait a few minutes before unplugging it.
2. Remove the filter (6).
3. Use a vacuum cleaner to remove the dust that has accumulated on the filter.
4. Replace the filter.

Heavily dirty filter

1. Soak the filter in warm water (max. 40°C).
2. Rinse it several times.
3. Allow the filter to dry thoroughly.
4. Replace the filter.

Never use the appliance without a filter.
Cleaning the outside Clean the outside with a soft, damp cloth and dry with a soft cloth.

Do not use aggressive or abrasive cleaning agents.

STORAGE

If the appliance will not be used for a longer period of time, take the following measures!

• Switch off the machine and unplug it.
• Clean and reinstall the filter.
• If possible, pack the appliance in its original packaging or in a plastic bag.
• Store the appliance in an upright position in a clean, dry and well-ventilated area no smaller than 11 m2.
• Do not place heavy objects on the appliance.

PROBLEMS AND SOLUTIONS

Before contacting our customer service, check whether the malfunction error can be solved by means of the solutions below.

TECHNICAL DATA

ENVIRONMENT
Your product, accessories and packaging should be sorted for environmental friendly recycling.
Only for EC countries Do not dispose of power tools into domestic waste. According to the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally friendly way.
Subject to change; specifications can be changed without further notice.

GUARANTEE
Refer to the enclosed guarantee conditions for the terms and conditions of guarantee.

VERKLARING VAN OVEREENSTEMMING CERTIFICAT DE CONFORMITÉ

KONFORMITÄTSERKLÄRUNG DECLARATION OF CONFORMITY

ART. NR. HYUNDAI 68509 TYPE NR. YGH-90D/3-W

Industrial dehumidifier

Dvize bv declares under its sole responsibility that this product is in conformity with the following standards or standardization documents:

EN 60335-2-40:2003 + A11:2004 + A12:2005 + A1:2006 + A2:2009 + A13:2012, EN 60335-1:2012 + A11:2014 + A13:2017 + A1:2019 + A14:2019 + A2:2019, EN 62233:2008,
EN 55014-1:2017 + A11:2020, EN IEC 61000-3-2:2019, EN IEC 61000-3-11:2019, EN 55014-2:2015, EN 301 489-1 V2.2.3, EN 301 489-17 V3.2.4, EN 300 328 V2.2.2,
EN IEC 62311:2020

Selon les dispositions des directives :

According to the provisions of the directives:

2014/35/EU, 2014/30/EU, 2014/53/EU

Testing authority:

SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd., China

Halter der technischen Dokumentation Keeper of the technical documentation:

A.N.P van Oort Directeur 01-01-2022
Dvize bv PO Box 150, 1910 AD Uitgeest, The Netherlands service@dvize.eu, www.hyundaiclimateproducts.nl

Dvize bv PO Box 150 1910 AD Uitgeest The Netherlands service@dvize.eu www.hyundaiclimateproducts.nl

Imported/Distributed by Dvize bv, The Netherlands

Licensed by Hyundai Corporation Holdings, Korea

References

• De beste mobiele airco's, luchtkoelers, buitenverwarming en gerelateerde producten van Hyundai voor een scherpe prijs.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>