Joker MACHINE 220808-I Indian Passenger Footpegs Installation Guide
- June 10, 2024
- Joker MACHINE
Table of Contents
Joker MACHINE 220808-I Indian Passenger Footpegs
Product Information
Indian Passenger Pegs
The Indian Passenger Pegs are designed and manufactured by Joker Machine. These pegs are easy to install and come with all the necessary hardware to mount them to your stock footpeg mount. The footpegs feature adjustable pitch and position to ensure maximum comfort for the passenger. They are made of high-quality materials that provide durability and longevity.
Product Usage
product Installation Instructions
- Start by contacting Joker Machine’s technical support if you need assistance with the installation process.
- Apply medium thread locker on all hardware provided with the pegs.
- If necessary, remove the existing footpeg from the mount before installing the Indian Passenger Pegs.
- Using the hardware provided, install the footpeg to the stock footpeg mount.
- If the footpeg is still together after step 4, loosen the 1/4 set screws found on the bottom of some footpegs and the 5/16 12 point screw.
- Adjust the footpeg to the desired position and tighten down the 5/16 12 point screw or 1/4 set screws firmly.
- Adjust the pitch adjustment screw found behind the footpeg mount as needed.
Note that Joker Machine denies any responsibility for any issues that may arise from failure to use liquid thread locker on all hardware provided with the Indian Passenger Pegs.
INSTALLATION
- NOTE: USE MEDIUM THREAD LOCKER ON ALL HARDWARE
- DISCLAIMER: Joker Machine denies any responsibility for any issues that may be caused from failure to use liquid thread locker on all hardware listed below
TOOLS NEEDED
- 5/16 12 Point Wrench
- 1/8 Allen Key/Driver
- 5/32 Allen Key/Driver
- 6mm Allen Key/Driver
- 13mm Socket
- Blue Loctite
- Retaining Ring Pliers
PROVIDED WITH PEGS
- (2) M8 – 1.25 Scoket Head Cap Screw
- (2) M8 – 1.25 Nylock Nut
- (2) Aluminum Spacer
- (2) 10-24 Socket Head Cap Screw (pre-assembled to footpeg mount)
Installation is easier in some cases if you remove the footpeg from mount first.
- Install footpeg to stock footpeg mount using the hardware Joker Machine provided.
- Loosen 1/4” set screws found on the bottom of some footpegs, and 5/16” 12 point screw if footpeg is still together after step 1. This will allow you to adjust the peg.
- Adjust footpeg to desired position and firmly tighten down 5/16” 12 point screw or 1/4” set screws.
- Adjust pitch adjustment screw found behind footpeg mount as needed.
For technical support contact Joker Machine
2245 Kiowa Blvd N. Ste. 100, Lake Havasu City, AZ 86403 PHONE:
909-596-9690, FAX:
909-596-9693
[email protected],
www.jokermachine.com