VISUAL COMFORT ARN 2500 Asalea 16 Inch Double Bath Sconce Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT ARN 2500 Asalea 16 Inch Double Bath Sconce
Asalea 16″ Double Bath Sconce Item # ARN 2500
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips Screwdriver
- Slotted Screwdriver
ASSEMBLY INSTRUCTIONS
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture by removing screws (D).
-
Install mounting plate (B) to the junction box and secure with the mounting screws (C).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE : It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION : Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture to mounting plate (B) and secure with screws (D).
-
Remove socket cover (F) and washer (G) from top socket (I), then install shade (H) to top socket (I) and secure with washer (G) and socket cover (F).
-
Remove socket cover (E) and washer (G) from bottom socket (K), then install shade (J) to bottom socket and secure with washer (G) and socket cover (E).
NOTE : Do not overtighten otherwise shade could become damaged. -
Install light bulb into the sockets.