Silver Cross 220406 Devon Cot Bed Instruction Manual
- June 4, 2024
- Silver Cross
Table of Contents
Silver Cross 220406 Devon Cot Bed
Parts list
Fittings list
Steps For Installation
WARNING : Be aware of the risk of open are and other sources of strong
heat, such as electric bars etc, in the vicinity of the cot/bed. WARNING: Do
not use the product if any part is broken, damaged, torn or missing. Approved
replacement parts can be obtained from Silver Cross.
WARNING : Do not leave anything in the cot/bed, or place it close to
another product that provides a foothold or presents a danger of suffocation
or strangulation. For example strings, blind/curtain cords etc.
WARNING : Children are likely to play, bounce, jump and climb on beds,
therefore the child’s bed should not be placed too close to other furniture or
windows, and should be placed either tight to any wall or have a gap of 300mm
between the wall and the side of the bed.
WARNING : Do not place this child’s bed near heat sources, windows and
other furniture. The lowest position of the mattress base is the safest and
should be used as soon as the baby is old enough to sit up. To prevent injury
from falls, when the child is able to climb out of the cot, the cot shall no
longer be used for that child. The thickness of the mattress chosen must not
reduce the internal depth (from mattress surface to top of the side) to less
than 500mm with the base in its lower position or 200mm with the base in its
higher position.
Maximum 10cm thick mattress to be used with this cot bed. If you leave the child unattended in the cot, always make sure that the dropside is in the highest position.
-
All assembly Settings should be tightened properly, checked regularly and re-tightened as necessary.
-
Screws and bolts should not be loose because a child can squeeze parts of the body, or clothing
e.g string, necklaces, ribbons for babies dummies etc. could get caught. There would be a danger of strangulation. -
The cot/bed must be used on a level and stable surface, away from electric sockets. Once assembled do not dismantle. Never move the cot/bed with a child in it.
-
Excessive chewing may damage the wood and cause splintering. If any part is damaged stop using until the correct replacement part has been obtained from Silver Cross.
-
Your cot/bed can be cleaned by wiping with a damp cloth and drying immediately with a soft clean cloth.
-
Do not use abrasives, bleach, alcohol or ammonia based household polishes.
-
Take care when handling or moving furniture, careless handling can damage wooden furniture.
-
Wood is a natural material, the colour will darken with age.
-
The size of the mattress to be used with the child’s bed is 1400x700mm.
-
Cot conforms to BS EN 716-1/2:2017 and toddler bed to BS 8509:2008+A1:2011. Cots which convert to toddler beds are intended from birth up to approximately 4 years.
-
The mattress length and width shall be such that the gap between the mattress and the sides and ends does not exceed 30mm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>