BROAN EW4330SS Code Ready Technology Activation Instructions
- June 10, 2024
- Broan
Table of Contents
CODE READY TECHNOLOGY™ ACTIVATION
EW4330SS Code Ready Technology Activation
The Code Ready Technology option allows to change the factory setting blower
output to less than 300 CFM. Activating the CRT option will reduce the
airflow, so that the hood will perform within the allowable limit of Make-Up
Air (MUA) codes (to meet some building code requirements). Do not change the
blower CFM setting unless this change is required by code. This change will
alter the performance of the product.
IMPORTANT NOTE : This change CANNOT be reverted.
HOW TO ACTIVATE CRT:
-
Be sure the range hood is OFF.
-
If needed, you can first verify which setting the hood is currently in. To do so:
– Press and hold keys “B” and “C” simultaneously for 6 seconds and release. Different combinations of LED indicators “1” through “3” will turn ON for 3 seconds, depending on the setting.
If set at 400 CFM (factory setting), LEDs “1”, “ 2” and “3” will light up.
If set at 300 CFM, LED “1” will light up. -
To change the setting, press and hold keys “B” and “C” simultaneously for 6 seconds and release, then:
To set the range hood at 300 CFM, press “A” until LED “1” alone flashes. -
Within 3 seconds, press key “B” to save and leave CRT activation mode.
-
Locate the CRT sticker near the HVI Certification label inside the hood, behind the filters. Check the proper box (300 CFM).
NOTES: – If no button is touched for more than 3 seconds while the hood is in CRT activation mode, the hood will exit the setting mode without saving the changes.
– An interruption of power to the range hood will not deactivate the CRT.
99046219A
Documents / Resources
|
BROAN EW4330SS Code Ready Technology
Activation
[pdf] Instructions
EW4330SS, EW4330SS Code Ready Technology Activation, Code Ready Technology
Activation
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>