nordlux NICO SQUARE Wall Light User Manual
- June 10, 2024
- nordlux
Table of Contents
NICO SQUARE Wall Light
User Manual
NICO SQUARE Wall Light
We congratulate you on your new outdoor lamp!
We congratulate you on your new outdoor lamp!
Guarantee
The Nordlux Outdoor lamps in copper, brass, tombac and galvanized are
guaranteed for up to 15 years. This guarantee applies to extensive corrosion
in the form of holes in the metal caused by rust.
The guarantee is subject to presentation of receipt.
There is not guarantee on the components which have been damaged by wear and
tear or mistreatment of the lamps
We congratulate you on your new outdoor lamp Stainless steel
Remember to take care of your lamp. Just follow the guidelines below.
The shiny, uniform and decorative surface of stainless steel makes it very
suitable for outdoor use.
It is an alloy consisting of iron, chrome and nickel. During bath pickling, a
thin, rustproof oxide layer forms on the surface. The surface is continually
vulnerable to atmospheric conditions, and from other effects of the close
environment.
This means that the lamp must be regularly maintained if its surface is to
remain shiny and untarnished by rust. Before setting it up, treat your lamp
with acid-free oil, and dry it off with a soft cloth. Repeat this three or
four times a year. Stainless steel lamps are not recommended for use in
aggressive environments such as coastal, agricultural or industrial areas.
Copper, Brass and Tombac fixtures
Our copper, brass and tombac fixtures are made from respectively solid copper,
brass and tombac. The mechanical machining will leave small scratches in the
surface, as well as residues of rinse aid. This rapidly disappears in the
patina process. After the first rain showers the copper / brass / tombak
surface will appear stained, but the aerated air and moisture will soon make
the lamp appear with dark brownish color.
Over the years, the material copper will get a beautiful patina-green color
and brass / tombac will get a darker and more uniform color. The uniformity of
the patina surface, as well as the rate at which the process occurs is
dependent on the environment that affect the fixture.
Aluminium fixtures
Our aluminium light fixtures are made from die-cast and/or extruded aluminium,
where the light fixture’s design determines whether both types of materials,
or just one of them, are used for different parts of the same light fixture.
Aluminium light fixtures in raw aluminium are subsequently coated with a
special clear coat, which seals the surface
to safeguard against corrosion. Painted aluminium light fixtures are powder-
coated and have a uniform and smooth surface. To avoid the light fixture
tarnishing, it is recommended to clean and wipe the light fixture after
mounting, and repeat this process 3-4 times each year.
This is done with a regular cleaning agent. Black light fixtures which are
bleached by strong sunlight can also benefit from treatment with silicone
spray as needed, to maintain the black color. Mounting light fixtures in
coastal, agricultural or industrial areas is not recommended, as these
aggressive surroundings may cause the light fixture to corrode, which may
entail spalling, bubbles in the surface and a whitish incrustation on the
light fixture’s surface.
- It is highly important that drainage holes are kept free of impurities if any.
BEFORE ASSEMBLING THE BOLLARD AGAIN DO REMEMBER TO WIPE OFF ALL PARTS!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>