PHILIPS RC4284505-02RP Remote Control User Guide

User guide for Remote Control RC4284505/02RP

RC4284505-02RP Remote Control

1. Know your Remote
   

2. How to pair your RCU with TV
   Step 1: input 2*AAA batteries to Battery compartment.
   Step 2: presses the Source key for 3 seconds.
   Step 3: After 3s, the blue LED blinks to acknowledge. The LED will blink when RCU in pairing mode.
   Step 4: When the user releases the key, RF pairing will start, the blue LED remains blinking.
   If pairing is successful, the blue LED will be turned off after successful pairing.
   Note: After RC goes into pairing mode, press any key before pairing successful will cancel and exit pairing mode except for keys and key.

3. Voice Function
   Press and released key to open the voice function, RCU will stop the voice transmission after receiving the stop command sent by the host or 20s timeout.
   The blue LED will be turned on for the full duration of audio sample transmission.

4. Ambilight key
   When press the key, the white LED will turn on and remain on 5 seconds.

5. Sleeping Mode
   When no activity needs to do, the RC enters sleeping for power saving purpose. The sleeping mode behaves as below:
   i) All LEDs are off.
   ii) IR and RF communications are stopped.
   iii) Any key press will wake up the RC.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Caution
Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>