GIRMI AP72 Vacuum Cleaner User Manual
- June 10, 2024
- Girmi
Table of Contents
BY TREVIDEA
User manual
Mod.: AP72
Technical model: SL594A06
Aspirapolvere
Vacuum Cleaner
PROTECTION CLASSES
WARNING
ELECTRIC SHOCK RISK
DO NOT EXPOSE TO RAIN OR MOISTURE
** This symbol warns the user that un-insulated dangerous voltage inside
the system may cause an electrical shock. Do not open the case.
Class II Appliance symbol. The double insulated electrical appliance is one
which has been designed in such a way that it does not require a safety
connection to electrical earth/ground.
Caution:** this symbol reminds the user to read carefully the important
operations and maintenance instructions in this owner’s guide.
SAFETY INSTRUCTIONS
The following are important notes on the installation, use and maintenance;
save this instruction manual for future reference; use the equipment only as
specified in this guide; any other use is considered improper and dangerous;
therefore, the manufacturer cannot be held responsible in the event of damages
caused by improper, incorrect or unreasonable use.
Before use, ensure the equipment is undamaged; if in doubt, do not attempt to
use it and contact the authorized service center; do not leave packing
materials (i.e. plastic bags, polystyrene foam, nails, staples, etc.) within
the reach of children as they are potential sources of danger; always remember
that they must be separately collected. Make sure that the rating information
given on the technical label are compatible with those of the electricity
grid; the installation must be performed according to the manufacturer’s
instructions considering the maximum power of the appliance as shown on the
label; an incorrect installation may cause damage to people, animals or
things, for which the manufacturer cannot be considered responsible thereof.
If it is necessary to use adapters, multiple sockets or electrical extensions,
use only those that comply with current safety standards; in any case do not
exceed the power consumption limits indicated on the electrical adapter and /
or extensions, as well as the maximum power shown on multiple adaptor. Do not
leave the unit plugged; better to remove the plug from the mains when the
device is not in use. Always disconnect from power supply if you leave it
unattended. Cleaning operations should be carried out after unplugging the
unit.
If the unit is out of order and you do not want to fix it, it must be made
inoperable by cutting power cord.
– Do not allow the power cord to get closer to sharp objects or in contact
with hot surfaces; do not pull it to disconnect the plug.
– Do not handle or touch the appliance with wet hands or bare feet. Do not
expose the appliance to harmful weather conditions such as rain, moisture,
frost, etc.. Always store it in a dry place.
– Do not use the appliance in the event of damage to the power cord, plug, or
in case of short circuits; to repair the product only address an authorized
service center.
– This appliance can be used by children of 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they received supervision or instruction concerning use of the
appliance in a safe way and understand hazards involved; children shall not
play with the appliance; cleaning and user maintenance shall not be made by
children without supervision.
– Children must not play with the appliance.
– Keep the appliance and its cord out of reach of children less than 8 years.
If the power cord is damaged, or in case of failure and / or malfunction do
not tamper with the unit. The reparation must be done by manufacturer or by
service center authorized by the manufacturer in order to prevent any risk.
Failure to comply with the above may compromise the unit safety and invalidate
the warranty. This appliance is intended to be used in household and similar
applications such as: staff kitchen areas in shops, offices and other working
environments; by clients in hotels, motels and other residential type
environments; farm houses, bed and breakfast type environments. The appliance
is not intended to be operated by means of an external timer or separate
remote-control system. Before every use, unroll the power cord. Use original
spare parts and accessories only. Do not subject the product to strong
impacts, serious damages may result. Do not use near or under flammable
materials (like curtains), heat, cold spots and steam.
GENERAL INFORMATION
CAUTION: Do not vacuum sharp objects, liquids, flammable, explosive or
hazardous to health materials, acids, combustible objects such as cigarettes
or firebrands.
If you need to change a filter, make sure that the reassembly is made properly
and new filters are not wet or damp. In this case, wait for it to dry
completely before assembling. Do not expose the appliance to high temperatures
and do not bring it closer to heat sources. Never leave the appliance
unattended while it is running. Always use the button to turn on or turn off
the vacuum cleaner. In case of overheating, if the unit produces smoke, smell
or unusual noises, turn it off immediately and check that the pipe is free
from obstacles. If the tube is free, contact the service center for fixing it.
To avoid serious damage, do not walk on the power cord. Disconnect the plug
from the electrical outlet immediately after use. Additionally it is advisable
to wind the power cord in order to ensure a better cleaning and to avoid any
risk of damage. Do not immerse the motor unit in water or other liquids, clean
it with a damp cloth only. Do not use the appliance if the dust bin is not
installed. Use only on dry surfaces. Caution when using the device on the
stairs.
CAUTION: while the unit is running, do not approach the air inlet to
ears, eyes, etc., or to fragile items such as vases, tools, electronic
machines.
DESCRIPTION AP72
- Floor brush
- Tubes
- Tube/Accessory release button
- Power switch
- Dust bin
- Handle
- Dust bin lid opening button
- Crevice nozzle
- Dust container Release button
INSTALL THE ACCESSORIES
-
Install the crevice nozzle
You can use the vacuum cleaner with the multifunction nozzle (8), to reach the most difficult corners, under furniture, for cleaning the upholstery (sofa, bed, armchairs) or for cleaning the car.
Proceed with the installation of the nozzle (8) directly to the power unit as shown in Fig 1. Add the tubes (2) in case you need to reach fa surfaces like the ceiling. Mount the nozzle (8) to the tube (2), and the tube to the motor housing. To remove the nozzle, press release button (3) and pull. -
Install tube and floor brush
Use the tubes (2) to connect the floor brush (1).
Insert the tube (2) in the suction hole until blocking, then connect the brush (1) to the lower part of tube (2).
You can mount only one or both tubes included. To remove the tube, press release button (3) and pull. -
Remove the dust bin
Press the release button (9) and pull the container extracting from motor housing. -
Install the dust bin
Insert the pin present on the container inside the lock present in the motor housing. Push the container one the motor housing until blocking.
SWITCH ON THE UNIT
– Connect the plug. Take the product in your hand and turn it on by pressing
the button (4).
– Always turn off the appliance before unplugging and putting it away.
CAUTION: the vacuum cleaner is powerful. Hold it firmly to prevent it
from falling causing damages or personal injury.
EMPTY THE CONTAINER
In order to ensure the best performances and having no losses in the air flow
and cleaning power, periodically drain the container.
CAUTION: before emptying and/or start cleaning the dust bin, unplug the
unit
from the main electrical outlet.
To empty the container, extract the container, take it above a bin and press
the release button (7) as shown in Figure 3. This button will open the door
dropping all the dirt. It is recommended to do this outdoors to avoid soiling
the house when the dust comes out of the trash. Close the lid.
CLEANING FILTERS
This vacuum cleaner is equipped with a metallic filter (a) and 1 HEPA filter
(b), capable of retaining particles and small organisms such as mites and
pollens. In this way the air reemitted from the cleaner will be more healthy
and clean. To maintain the performance of the vacuum cleaner is recommended to
clean the filters regularly.
– Release the container (5) and clean it, as described in the previous
paragraph.
– Take the filtering system out of dust container.
– Go over a bin and take out the HEPA filter (b), pulling it out of filtering
system (a).
a) The filtering system with metal mesh filter can be washed with running
water.
b) Clean HEPA filter as described below. Linked to the HEPA there is a black
sponge filter: take it and shake in a bin. At least once a week, shake the
HEPA filter in the bin to get the dirt out. At least once every 2 months,
carry out a more thorough cleaning: rinse HEPA filter, metal filter and
container with a soft brush and/or with warm water and DRY THEM THOROUGHLY.
CAUTION: Do not use detergent to clean the filter or the cover. The HEPA
filter must be completely dry before using the vacuum cleaner.
After cleaning:
– Place the black sponge filter in its seat.
– Mount HEPA (b) in the filtering system (b).
– Mount the filtering system in the dust container. Warning: the filtering
system is mounted well only if the lateral protuberances on the upper part of
filtering system enter correctly in the shapings of the container.
– Mount the container in the motor housing.
PROBLEMS AND SOLUTIONS
PROBLEM | CAUSE | SOLUTION |
---|---|---|
The cleaner does not work | The unit is not correctly connected Electricity is | |
down. | Plug the unit. |
Check the distribution board.
Suction power is weak| The container is full.
The unit is obstructed.. Filters need to be cleaned.| Empty the container.
Unplug and check if something obstructs the unit Clean or change the filter.
Dirt comes out of the container| Container is full.
Not correctly installed. Broken container.| Empty the container and installi t
again. Replace the container.
Unit cannot vacuum| Blocked hose.
Dust container is full.| Remove objects inside the hose.
Empty the container and clean the filters
MAINTENANCE AND CLEANING
CAUTION: before starting any operation, unplug the unit from the
electrical outlet.
Normally this vacuum cleaner is not noisy. But when the dust container is full
or the HEPA filter is clogged, the noise emitted changes, so the suction
power. In addition, thanks to the transparent container, you can see the
amount of dirt making it very easy to understand when you need to empty the
container. Even the filters should be cleaned periodically. These filters can
also be damaged or exhausted (HEPA filter) and should be replaced with new
filters. Emptying the dust container and cleaning the filters as stated in
this booklet, you will avoid stressing the motor.
Clean the main body with a damp non-abrasive cloth, avoiding the use of
aggressive detergents or abrasive cleaners, which could ruin the aesthetic
parts of the device.
The cloth should not be too wet, since the water penetrating the device, can
seriously damage it. Cleaning filters by following the specific instructions
on this guide.
TECHNICAL FEATURES
- Power supply: AC 220-240V~50-60Hz, 600W
- Dust capacity 0,6 lt
- Vacuum 15 kPa
- Accessories: 2 tubes, floor brush, multi-crevice nozzle, wall mount set
SPARE FILTERS: ask to your reseller the spare filter set, model Girmi AP73
WASTE OF ELECTRIC AND ELECTRONIC EQUIPMENT
The product is made of non-biodegradable and potentially polluting substances
if not properly disposed of; other parts can be recycled. It’s our duty to
contribute to the ecological health of the environment following the correct
procedures for disposal. The crossed out wheelie bin symbol indicates the
product complies with the requirements of the new directives introduced to
protect the environment (2002/96/EC, 2003/108/EC, 2002/95/EC, 2012/19/EC) and
must be properly disposed at the end of its lifetime. If you need further
information, ask for the dedicated waste disposal areas at your place of
residence. Who does not dispose of the product as specified in this section
shall be liable according to the law.
To find the nearest service center, please call the telephone number 0541
694246, fax number 0541 756430 or contact us at
assistenzatecnica@trevidea.it asking
for the service centers supervisor.
**** Appliance is conform to the pertinent European regulation and is
therefore marked with the CE mark.
www.girmi.it TREVIDEA S.r.l.
TREVIDEA S.R.L. – Strada Consolare Rimini – San Marino n. 62 – 47924 –
RIMINI (RN) – ITALY
MADE IN CHINA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>