Blackview W2 Wireless Charger User Guide
- June 9, 2024
- Blackview
Table of Contents
Blackview W2 Wireless Charger
Charger Setup
- Connect USB-C to the power source. An output of 45W is recommended.
- Connect the Type-C adapter to the charging pad.signaling device is turned on and on stand-by mode.
- Place the phone on the center charging pad, matching its induction point. When charging, the blue LED light will stay on.
- Follow the Blackview community, a place where you can share and discuss with Blackview users and keep posted with the most up-to-day news
Specification
Applicant
- Name: DOKE COMMUNICATION (HK) LIMITED
- Address: RM 1902 EASEY COMM BLDG 253-261 HENNESSY
- ROAD WANCHAI HK CHINA
Manufacturer
- Name: Shenzhen DOKE Electronic Co., Ltd
- Address: 801, Building3, 7th Industrial Zone, Yulv Community
- Yutang Road, Guangming District, Shenzhen, China.
EU-
- This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out. This restriction will be applied to all Member States of
European Union.
- The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Declaration of Conformity
- Hereby,DOKE COMMUNICATION (HK) LIMITED declares that the product type W2 is in compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.blackview.hk
FCC
Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement
- The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.
- Shenzhen DOKE Electronic Co,Ltd
- Address: 801, Building3, 7th Industrial Zone, Yulv
- Community, Yutang Road, Guangming District,
- Shenzhen, China.
Documents / Resources
|
Blackview W2 Wireless
Charger
[pdf] User Guide
W2, 2A7DXW2, W2 Wireless Charger, Wireless Charger, Charger
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>