TOPBAND A1T Standing Hair Dryer User Manual

TOPBAND A1T Standing Hair Dryer

Packing List

• Main body (Include teles copied) 1 set
• Base 1 set
• Remote controller 1 set
• User manual 1 set

This user manual is applicable to A1D/A1T product model. Please read this manual carefully and keep it properly before using the product. Website: www.sunselectiontech.com.

CAUTIONS AND NOTE

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Installation guide

Instructions

1. Insert the power plug into the socket;
   (Different counties apply to local plug and socket, the picture below for illustration only)

2. Please adjust the angle of the head according to the direction shown in the figure;
   Warning: Do not reversely adjust or rotate the air duct 360, otherwise it may damage the machine, cause a short circuit, and fire.

3. The height of the telescopic rod can be adjusted after rotating the elastic ring.

4. Press the power button You will hear a beep. The hair dryer is powered on. Adjust the hair dryer with the remote controller.

Warning Use and storage

• Do not repair, disassemble or refit this product by yourself, otherwise, you may be injured due to fire or abnormal action. If you need to repair it, please call the company’s service phone.
• Children should be supervised to ensure that they do not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• Do not change the use scene or conditions, expand the transmission frequency range, or increase the transmission power (including adding an additional RF power amplifier.
• Do not use the remote control in an area with a radius of 5000 meters centered on the center point of the airport runway.
• Do not use the hair dryer in the bathroom, otherwise, it may cause electric shock even after the on-off switch is disconnected.
• In order to increase protection, it is recommended to install a residual current device (RCD) with a rated residual working current not exceeding 30mA in the power supply electrical circuit of the bathroom. If it needs to be purchased separately, consult the RCD installer.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

Product introduction

WARNING Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

Detailed instructions for remote control

Product Features

1. The standing hair dryer can be directly used for 100-120V D220-240V 50/60Hz power supply and has six grades to adjust temperature and other different modes, to meet various needs.
2. The hair dryer has negative ion hair care technology, which is conducive to reducing static electricity, tig then hair scales, reducing hair irritability and making hair more healthy and more bright.
3. The negative ions are effective in all modes.
4. Various height factors are considered red, so you can enjoy the good experience of sitting down and blowing your hair at home.

Abnormal status operation guide

Instruction for Back up button
If the remote controller does not work, the backup button can be used to start the hair dryer in an emergency.

Double-click the backup button to start, it goes directly into Hot Mode, then click, and it goes into Cool Mode, next click, it will be off.

Remote controller Re-Connect

Please re-connect the remote controller if the product is under the following situation:

1. Back up button is on a red light
2. The remote controller has electricity, but can not control the hair dryer.
   • Prepare: make sure that the hair dryer is powered on.
   • Press and hold the back-up button 3 seconds, then you will hear a beep, now you can release your hand, the blue light is flashing
   • Now press the ON/OFF button
   • When the indicator light changes from flashing blue to stable blue or off. it is complete.
     The blue light is always on or off. the pairing is completed

The instructions for remote controller battery replacement

If the light does not light up after the control is turned on, the battery may be insufficient; Please replace the battery in the following ways:

• Pull out while pressing the left side to extract the battery compartment.
• Pushin the compartment and you can use it normally.

Note: When the battery is replaced, if the remote controller can not control the hairdryer, please reconnect with the main body.

Maintenance and service

Make sure the on-off switch is off and unplug the power plug when cleaning the hair dryer. Please regularly use a towel, cotton swab, or toothbrush to remove the attachment of the air inlet and outlet regularly Do not press or rub the air inlet and outlet with nails or sharp objects to avoid damaging the product. Do not use alcohol, nail washing water, or detergent to clean this product, otherwise, it may cause failure, cracking, or fading.

Product safety cautions

In order to reduce the risk of failure, electric shock, injury, fire, death, and damage to equipment or property, be sure to observe the following safety precautions.

Mark instructions

• Warning Indicates a potential hazard that could result in serious injury or death.
• Notes indicate a risk of minor injury.
• This mark is used to remind the user of the prohibited action steps.
• This sign is used to remind the user must be followed operational steps in order to keep safe.

Warning

Power cord and power plug

• Do not use it when the power cord or plug is damaged or heated, otherwise, it may cause scald, electric shock, or fire due to short circuits.
• Do not use it when the power plug is loose otherwise, it may cause scald electrical shock or fire due to a short circuit.
• Do not unplug the power plug when your hands are wet otherwise it may cause electric shock and injury.
• Do not use it when the power cord is tied otherwise it may cause electric shock or fire due to a short circuit
• Do not damage, modify, bend, pull, or twist the power cord, place heavy objects on the power cord, or squeeze the power cord, otherwise, it may cause electric shock or fire due to short circuits.
• When unplugging the power plug. do not pull the power cord Be sure to pull it out by holding the power plug. otherwise, the power cord may be disconnected, scalded, electric shock, or fire due to a short circuit
• Fully insert the power plug Please use the socket alone and do not use the power terminal block, otherwise it may cause electric shock or fire due to a short circuit
• If the power cord is damaged, it must be replaced by professionals of the manufacturer, its maintenance department, or similar departments in order to avoid danger.

Warning

Use and Storage

• Do not place the air inlet of the hair dryer downward in the working state otherwise, it may cause the heating wire to turn red and cause a fire.
• Do not block or insert foreign matters into the air outlet and air inlet, otherwise it may cause scald, electric shock or fire due to high temperature or short circuit
• Do not cover the air inlet and outlet with towels and clothes, otherwise, it may cause scald, electric shock, or fire due to high temperature or short circuit.
• The hair dryer is only designed for hair-blowing functions. Do not use the hair dryer for dry clothes and other non designed uses.
• Do not immerse the hair dryer in water.
• Do not use this hair dryer in a humid environment
• Please keep the hair dryer dry, otherwise, it may cause an electric shock.
• Do not use with wet hands otherwise electric shock or fire may occur due to a short circuit.
• Do not use near LPG or other inflammable products (such as volatile agents, paint thinners, sprays, etc.), otherwise, it may cause an explosion or cause a fire due to a short circuit
• Do not leave the product with the power on, otherwise, fire may be caused by a short circuit
• Do not wrap the power cord around the main body of the product during storage, otherwise, the power cord may be disconnected, electric shock, or fire due to a short circuit.
• Do not store it in a highly humid place, otherwise, it may cause electric shock or fire due to a short circuit.
• Do not store it in the contact range of children and infants, otherwise, it may cause electric shock and injury.
• Do not use this appliance near the bathtub, shower, wash basin, or other utensils containing water.
• Do not store or use it outdoors in places prone to rain, otherwise, it may cause electric shock or fire due to a short circuit.

In case of abnormality or failure
In case of abnormality or failure, such as no air, frequent stop, internal redness, and smoke, please stop using it immediately, unplug the power plug, and call the company’s service phone. In this case, the use of this product may cause electric shock, injury, or fire due to a short circuit.

Operation instructions

1. In the process of using the air outlet and nozzle may become hot. Do not touch them with your hands, otherwise, they may cause burns.
2. Please avoid dropping the hair dryer or strong impact on the hair dryer, otherwise, it may cause electric shock or fire due to a short circuit.
3. Please do not use it when the air inlet is damaged, otherwise, the hair may be drawn into the air inlet, resulting in hair damage.
4. Please do not use it on infants, otherwise, it may cause burns
5. Please do not store the power cord when it is twisted, otherwise, it may cause the power cord to break, scald, electric shock, or fire due to a short circuit.
6. This product is only used to dry hair. Do not use it to dry shoes and clothes otherwise, it may cause scald or fire due to a short circuit
7. The blower is equipped with overheating automatic power-off protection. When the blower temperature is too high, it will automatically stop operation. In this case, please turn off the power supply of the hair dryer immediately. And remove the power plug from the power socket and check whether the air inlet and outlet are blocked by hair or foreign matters. If there is no foreign matter, restart the power switch after the blower is cooled for2 3 minutes; If there are foreign matters, please contact the after-sales customer service immediately Do not operate by yourself
8. The hair dryer is equipped with 30min automatic diagram. Please take the physical products the standard-off protection. When the hair dryer works continuously for 30min without operation, it will automatically stop working, so as to avoid forgetting to shut down or mistakenly touching the start resulting in the long-term operation of the machine without adult monitoring To continue using please restart.
9. The telescopic rod of the hair dryer is connected and fixed with the base through a coupler. When shaking the hair dryer by hand, it ill shakes slightly, which is a normal phenomenon. Please set your mind at rest to use.
10. The illustrations of products and accessories in the manual are schematic diagrams for reference only. Due to the update and upgrade of the product, the physical product may be slightly different from the schematic.

During usage, do not touch the net on the air outlet of the hair dryer to avoid scalding.

Please ensure that the hair is kept more than 30cm away from the air inlet when using the hair dryer to avoid the hair being drawn into the hair dryer. Please ensure that the hair is kept more than 10cm away from the air outlet to avoid hair burns.

Specification

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>