Panasonic ET-LAV300 Replacement Lamp Unit Instruction Manual

Panasonic ET-LAV300 Replacement Lamp Unit

Thank you for purchasing this Panasonic product.

• Please read these operating instructions and the projector operating in-structions carefully, and then use this product correctly.
• Before using this product, be sure to read [Read this first!].
• Please save this manual for future use.

Read this first

WARNING:
Do not remove any screws other than those indicated when replacing the lamp unit. If this is not observed, electric shocks, burns or other injuries may occur.

• Do not disassemble the lamp unit.
  If the lamp breaks, it could cause injury.

• Lamp replacement
  The lamp has high internal pressure. If improperly handled, an explosion and severe injury or accidents will result.

• The lamp can easily explode if struck against hard objects or dropped.

• Before replacing the lamp, be sure to disconnect the power plug from the wall outlet. Electric shocks or explosions can result if this is not done.

• When replacing the lamp, turn the power off and allow it to cool for at least 1 hour before handling it otherwise it can cause burns.

CAUTION:

• Do not use the old lamp unit.
  If used it could cause lamp explosion.

• If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces. Failure to observe this will cause the user to absorb the gas which was released when the lamp broke and which contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces will cause injury.

• If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical advice immediately.

• Ask your dealer about replacing the lamp unit and check the inside of the projector.

Illustrations in these operating instructions
Illustrations contained in these operating instructions that show the projector may differ from the actual objects they depict.

Notice (for USA only)
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws, See: www.lamprecycle.org or 1-888-411-1996

This lamp is used in projectors.
It is not intended to be used for indoor lighting of ordinary homes.

English
Manufactured by: Panasonic Connect Co., Ltd.
4-1-62 Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Importer: Panasonic Connect Europe GmbH
Authorized Representative in EU: Panasonic Testing Centre Winsbergring 15, 22525 Hamburg, Germany
Importer for UK:
Panasonic Connect UK, a branch of Panasonic Connect Europe GmbH, Maxis 2, Western Road, Bracknell, Berkshire, RG12 1RT

Deutsch
Hergestellt von: Panasonic Connect Co., Ltd.
4-1-62 Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Importeur: Panasonic Connect Europe GmbH
Vertretungsberechtigter in der EU: Panasonic Testing Centre
Winsbergring 15, 22525 Hamburg, Deutschland

Replacing the Lamp unit

Attention

• The light source lamp is a glass component. If it is hit on a hard object or dropped, breakage may occur.
  Be careful when handling a light source lamp.

• Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and may cause injury.

• Do not disassemble or modify the lamp unit.

• When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken. If replacing the lamp of a projector that has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.

• The lamp contains mercury. Contact the local government office or distributor for the correct disposal of the old lamp unit.

• When the projector is mounted on a ceiling, do not work with your face close to the projector. z Attach the lamp unit and the lamp cover securely.

• When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the lamp, the connector may be damaged.

• Panasonic Connect Co., Ltd. takes no responsibility for any damage or malfunction of the product resulting from use of lamp units that are not manufactured by Panasonic Connect Co., Ltd. Use only specified lamp units.

• Do not loosen other than designated screws.

Note A Phillips screwdriver is necessary when carrying out replacement. Hold the screwdriver firmly.

Replacement procedure

1. Turn off the Power and then remove the AC power plug from the wall outlet. Wait at least one hour and make sure the lamp unit and surroundings are cool.
2. Use a Phillips screwdriver to loosen the Lamp cover fixing screw (one screw) and remove the lamp cover.
   • Remove the lamp cover by pulling it slowly toward the direction of the arrow.
3. Use a Phillips screwdriver to loosen the lamp unit fixing screws (three screws) until the screws turn freely.
4. Hold the used lamp unit by its handles, and pull it gently from the projector.
5. Insert the unused lamp unit in correct direction. Tighten the lamp unit fixing screws (three screws) securely with a Phillips screwdriver.
6. Attach the lamp cover. Tighten the lamp cover fixing screw (one screw) securely with a Phillips screwdriver.
   • Attach the lamp cover by pushing it slowly opposite the direction of the arrow.

Note When you replace the lamp unit with new one, the projector resets the runtime of the lamp unit automatically.
Attention After unpacking the lamp unit, discard the packaging material properly.

Disposal of Old Equipment

Only for European Union and countries with recycling systems
This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation. By disposing of them correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment. For more information about collection and recycling, please contact your local authority. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.

Panasonic Connect Co., Ltd.
WebSite: https://panasonic.net/cns/projector/
© Panasonic Connect Co., Ltd. 2022

References

• Lamp Recycle – Environmental Responsiblility Starts Here
• Projector | Panasonic Global

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>