VENTURE LIGHTING BO0003 LED Sensor Mounting Kit Instruction Manual
- June 9, 2024
- VENTURE LIGHTING
Table of Contents
BO0003 LED Sensor Mounting Kit
Instruction Manual
BO0003 LED Sensor Mounting Kit
Before You Begin
Read These Instructions Completely and Carefully
Motion Sensor Installation Instructions
(VSolution Fixture with or without Reflector)
STEP 1: Remove terminal block cover and attach block base to mounting
plate A with two M3 screws.
STEP 2: Attach mounting plate/terminal block assembly to fixture with two
M4 screws.
Figure
1: Attach terminal block to fixture
STEP 3: Attach sensor to fixture or reflector.
For Fixtures without Reflector:
A) Attach sensor to mounting plate B (M3 screws).
B) Attach mounting plate B to fixture (M4 screws).
Figure 2: Attach sensor to fixture
(fixture without reflector)
For Fixtures with Reflector:
A) Unscrew thumbscrew enough to clear reflector lip.
B) Firmly pry open lever spring and place sensor on reflector. Slowly
release spring against inside of reflector to secure sensor.
C) Tighten thumbscrew to further secure sensor to reflector lip.
STEP 4: Route wires into terminal block though cord reliefs. Complete
wiring inside terminal block as shown in diagram below using provided wiring
caps. 
STEP 5: Attach terminal block cover. Program sensor according to instructions included with sensor.
Figure 6: Attach
cover to terminal block
(fixture shown with reflector)
800-451-2606
6675 Parkland Blvd., Suite 100
Solon, Ohio 44139 USA
E-mail:
Venture_Lighting@VentureLighting.com
VentureLighting.com
http://www.venturelighting.com/
© 2022 Venture Lighting Internationa
Venture Lighting is a registered trademark of Venture Lighting International.
BO0003-B
Documents / Resources
|
VENTURE LIGHTING BO0003 LED Sensor Mounting
Kit
[pdf] Instruction Manual
BO0003 LED Sensor Mounting Kit, BO0003, LED Sensor Mounting Kit, Sensor
Mounting Kit, Mounting Kit, Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>