thecoopidea CP-ADP08 GaN BLOCK 65W 3 Ports PD Plus QC Fast Charge Adapter User Manual

: June 9, 2024
: Thecoopidea

Table of Contents

thecoopidea
- Model No.: CP-ADP08
USER MANUAL
GaN BLOCK 65W

thecoopidea

Model No.: CP-ADP08

thecoopidea CP-ADP08 GaN BLOCK 65W 3 Ports PD Plus A1

USER MANUAL

GaN BLOCK 65W

3 PORTS PD+QC FAST CHARGE ADAPTER

thecoopidea CP-ADP08 GaN BLOCK 65W 3 Ports PD Plus
A3

Inside the Box

1 x GaN BLOCK 65W Adapter
1 x User Manual

Appearance & Interface Description

1 Movable Pin
2 UK Pin
3 Type-C Output (20W Max)
4 Type-C Output (65W Max)
5 USB-A Output (18W Max)

How To Use

Pull out the Movable Pin and make sure it fits into a UK power socket.
Plug in GaN BLOCK 65W to a properly installed power socket.
Connect GaN BLOCK 65W and your device via a compatible charging cable to start charging.
Disconnect the device and charging cable from the GaN BLOCK 65W when the device is fully charged or to stop charging.
Unplug GaN BLOCK 65W from the power socket.

Note:

Please make sure the output power of the power socket meets the input requirements of GaN BLOCK 65W. Higher or lower voltage is unsuitable.
The maximum charging rate may affected by the restriction of your device or charging cable. Please check your device and charging cable before use.

thecoopidea CP-ADP08 GaN BLOCK 65W 3 Ports PD Plus A4

Explanation Of Warning Symbols & Notes

This product is compliant with the CE directive.

This symbol indicates uninsulated material within your unit may cause an electrical shock. For safety, please do not remove product covering.

This symbol indicates direct current.

This symbol indicates attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.

Do not dispose of your product with other household waste. Please act according to the local rules on the separate collection of electrical and electrionic products and batteries. The correct disposal of those products helps prevent potentially negative consequences on the environment and human health.

This product complies with FCC certification.

This symbol indicates that this product is for indoor use only.

This symbol indicates that this product has a double insulation system.

Specifications

Input	: 100-240V ~ 50/60Hz 1.5A
Output :	Type-C 2 (PD 3.0)

Precautions

Please read all safety instructions and warnings thoroughly before using this product. Improper use of this product may result in damage to this or attached products.

Do not disassemble the product or attempt to fix it.
Do not attempt to replace any part of this product.
Do not crush, puncture, dispose of in fire, short the contacts or expose the product to water or other liquids.
Do not store or use the product in a high temperature environment, including intense sunlight or heat.
Avoid drops, bumps, abrasions and impacts.
If there is any reason to believe that there is damage to the product, discontinue use immediately.
If you find that the product is too hot, or is emitting an odor, or is deformed, punctured or exhibits any suspicious or abnormal behavior, discontinue use immediately.
Do not operate the product beyond the power limits given in the specifications.
Use the product for its intended purpose only.
Use the product in dry rooms only.
Keep this product out of the reach of children.
Always pull directly from the plug when disconnecting the cable, never on the cable itself.
Route cables to avoid tripping hazards.
When using a multi-socket power strip, make sure that the sum power draw of all the connected devices does not exceed its maximum throughput rating.
If the product will not be used for a long time, please disconnect from main power.

Warranty Terms & Conditions

The product comes with a factory warranty for twelve (12) months from the date of purchase. Your product is in perfect condition. In the event where a replacement umit is needed, the owner must provide the original receipt of purchase in order to grant replacement, providing the defect falls under warranty terms. If your unit has been disassembled or repaired without the manufacturer’s authorization, the warranty will be immediately voided. The owner is responsible for any fee and charges of delivering the unit back to the agent or manufacturer.

The Coop Idea Ltd. Inspirations from New Zealand.
Design in Hong Kong. Produced in China.

W www.thecoopidea.com thecoopidea