VENTURE LIGHTING AC0004 Surface Mount Sensor Canopy Fixture Installation Guide
- June 9, 2024
- VENTURE LIGHTING
Table of Contents
VENTURE LIGHTING AC0004 Surface Mount Sensor Canopy Fixture Installation
Guide
OVERVIEW
WARNING: Before proceeding, read all instructions carefully to ensure
proper and safe installation.
WARNING: Risk of fire or electrical shock.
WARNING: Disconnect power before installing or servicing.
WARNING: All wiring to be performed per National Electrical Code and
local code by a qualified electrician.
Installation Instruction
-
Unpack fixture from packaging.
Fixture consists of the power supply(s) mounted on the back plate inside of the fixture.
Surge protector mounted on the mounting bracket (optional). -
Remove rear cover plate screws.
-
Mount back plate to surface using the provided slots.
Use temporary hanging cable and hook for ease of installation.
Electrical wire opening and pendant mount hole. -
Connect the incoming electrical wires to the set of power wires on the LED power supply(s).
Next connect the LED driver harness(s) to the LED light engine(s) on main housing.
The surge suppressor is an optional accessory that can be used in the system.
Warning:
Do not allow the fixture to hang from the harness.
This may cause damage to the circuit. -
Pendant Mount Installation
Feed the electrical wire coming out of the fixture though the conduit pipe as shown below.
Connect wires to the appropriate wires at electrical junction box as shown in electrical diagram.
Mount to junction box using the proper mounting plates.
**(Optional Bird Guard)
**
- Mount the bottom housing to the cover plate using the 4 screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>