VENTURE LIGHTING AG0003 Surface Mount Kit for LED Panel User Manual

: June 9, 2024
: VENTURE LIGHTING

Table of Contents

UNPACKING
IMPORTANT SAFETY INFORMATION
WARNING
Upgrade Instructions
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VENTURE LIGHTING AG0003 Surface Mount Kit for LED Panel

UNPACKING

Unpack and carefully examine the product.
Report any damages and save all packing materials if any part(s) were damaged during shipping.
Do not attempt to use this apparatus if it is damaged.

CAUTION: Risk of Electric Shock

IMPORTANT SAFETY INFORMATION

Suitable for dry locations.
Maximum ambient temperature is 40°C.

WARNING

Risk of fire and electric shock

Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
Venture Lighting’s surface mount kit installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
The product should be installed and operated by a qualified electrician or technician in accordance with relevant local codes.
Check to make sure that all fixture connections have been properly made and the fixture is grounded to avoid potential electrical shocks.
Do not handle energized fixture when hands are wet, when standing on wet or damp surfaces, or in water.
These panel lights are normally set to work at extra low voltage below DC42V and constant current conditions to ensure safety to human body.
Designed for use with 100V-277V, 50-60 Hz input. It is the installers responsibility to confirm the proper input voltage is available.
Suitable for use in dry locations only

Upgrade Instructions

STEP 1: Disconnect power from the existing luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
STEP 2: Dispose of the existing fixture, lamp(s), and ballast(s) per local requirements.
STEP 3: The surface mount frame is made up of two (2) Frame A sides (with openings to secure the frame to the ceiling) and two (2) Frame B pieces (end caps). (Figure 1)

STEP 4: Secure one Frame B piece to two (2) Frame A sides using the flat head screws provided. (Figure 2)

STEP 5: Mount the frame sub-assembly to the ceiling using the hardware provided. (Figure 3)

STEP 6: Remove knock-out(s) on the fixture junction box and make the proper wire connections.
STEP 7: Connect the main input wires to the L (Black) and N (White) input wires of the LED Driver. Connect the fixture ground wire to the incoming ground. (Figure 4)

Ensure the LED Driver output connections are secure. (Figure 4)
Connect the LED Driver Dim+ wire (Purple) to the Dimmer D+ wire. (Figure 4)
Connect the LED Driver Dim- wire (Gray) to the Dimmer D- wire. (Figure 4)
NOTE: The polarity of these dimming connections is important to ensure the fixture performs as desired.
NOTE: If not using dimming functionality, DO NOT connect the Driver Dim+ (Purple) to the Driver Dim- (Gray). The fixture will not operate as desired.
STEP 8: Replace the junction box cover on the fixture and slide the fixture into the frame sub-assembly. (Figure 5)

STEP 9: Secure the remaining end frame piece to the sub-assembly using the flat head screws provided.
STEP 10: Switch on the power.