Knightsbridge MLBA6045F LED Bathroom Mirror with Frosted Panels Instruction Manual
- June 9, 2024
- Knightsbridge
Table of Contents
Knightsbridge MLBA6045F LED Bathroom Mirror with Frosted Panels Â
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by
the end user for future reference and maintenance.
These instructions should be used to aid installation of the following
products: MLBA6045E / MLBA6045F
SAFETY
- Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
- This product is for indoor use only
- This product is IP44 rated
INSTALLATION
-
Mark the location of the fixing holes (see Fig. 1) and drill the holes ensuring not to infringe with any gas/water pipes or electrical cables
-
Insert the plugs fully into the wall, and screw in the 2 screws provided, leaving them approximately 2-3mm proud of the wall surface
-
Remove the lid from the battery enclosure
-
Open the battery compartment by removing the screw and sliding in the direction shown by the arrow
-
Insert 8 x AA batteries (not included) observing the polarity shown on the base of the compartment, and replace the battery compartment lid
-
Ensure that the sliding switch on the outside of the battery compartment is in the ON position (see Fig. 2)
-
Refit the battery enclosure lid
-
Hang the fitting onto the fixing screws
-
Switch on and check for correct operation
GENERAL
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the product. A glass cleaning solution may be used on the mirror surface. This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist.
WARRANTY
This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice.
Supplied By:
-
(UK) Manufacturer
ML Accessories Ltd, Unit E Chiltern Park, Boscombe Road, Dunstable LU5 4LT,
www.mlaccessories.co.uk -
(EU) Authorised Representative
nnuks Holding GmbH, Niederkasseler Lohweg 18, 40547 Düsseldorf,
Germany, www.nnuks.com
Email: eprel@nnuks.com
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>