ALLSPARES AS-FF180 Refrigerator Water Filter Instruction Manual
- June 9, 2024
- ALLSPARES
Table of Contents
ALLSPARES AS-FF180 Refrigerator Water Filter
A replacement for the following water filters
BOSCH” filters
644845, REPLFLTRl 0, BT-644846, BT644845, 641425, 740560, 740568, D570104, 499850, 667256, 101443, 101443-A, 667256, AP3962558, 643046, 740572, D405434, 9000077095, 9000077096, 9000077104, 9000194412, 9000 077104, 9000 193 914, 9000194412, 9000225170, 9000077095, 9000077 096, 1014430109, 1014430510, 1017320109, 1017320109
Haier filters
0060218743, 0060820860, RF-2800-13, RF-2800-15, 10169, 1016986, 101699, 1016998, 9557031, RF280013, RF280015, 0060822300, 3038882
Tested and Certified by NSF International against NSF/ANSI Standard 42 in model AS-FFl 80 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (s0.25% lead).
Installation instructions
Before installation
- Shut off the cold-water supply to the refrigerator before installing. Turn on the refrigerator water dispenser to release water pressure, letting water drain from the pipe completely.
- It is normal for black carbon fines (particles) to appear on the outside of your filter. This happens when the filter is jarred in shipping. It is safe to simply wipe it off.
- The filter connectors are larger to prevent leaks. You might have to twist the filter hard to make sure the connection is secure.
- Twist the old filter a half-turn counterclockwise.
- Pull the filter straight out.
- Discard the old filter.
- Push the new filter into the fridge until it stops.
- Twist the filter a half-turn clockwise.
- Reset your “change filter” light (if your fridge has one).
Storage and maintenance
- Replace your filter every 6 months or 11 OOL to prevent bacteria and fungus growth in your filter, supply lines, and storage tank.
- Keep your unused filters in a cool, dark, and dry place until you need them.
- If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad-tasting water.
Frequently asked questions
- Q: Why is it difficult to twist the new filter into the filter housing?
- A: The connector may expand because of water pressure. Therefore, it is recommended you push the new filter in with a little bit of force, but not too hard. Then turn it clockwise.
- Q: Do I need to flush the filter after installation?
- A: After installation, it is highly recommended you run water for a few minutes before using. Water filters are made from advanced coconut carbon block, so there are some carbon fines in the filter. Flushing removes the carbon fines to produce clean water.
- Q: Must the filter be changed every 6 months?
- A: Yes, you must replace the filter every six months or sooner if water flow is reduced or if there is heavy sediment/ rust present. Over-used filters will degrade the filtration performance.
Warning
To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions. This filter unit must be replaced every 1100 L or 6 months. Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.
- BOSCH is a registered trademark of BSH Home Appliances Corp.
- BOSCH is used for reference purposes only.
- The service life mentioned above is subject to chlorine reduction. The actual result varies according to the local water quality.
Operating specifications
- Operating Temperature: 33 -100°F/0.6 – 38°(
- Working Pressure: 20 -100 psi/140 -689 kPa
- Rated Capacity: 300 ga!lons/1, 137 liters
- Flow Rate: 0.5 gpm/1.9 lpm
Substance reduction
The system has been tested and certified by the NSF International according to NSF/ANSI Standard 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.
Warning: Do not use with water that is micro-biologically unsafe or of unknown water quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts.
Power Components B.V.
- Bergweg 165A 3707AC, Zeist The Netherlands
- Email: info@allspares.com
Manufactured by Qingdao Ecopure Filter Co., Ltd in Qingdao, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>