ALLSPARES AS-FF140 Water Filter Instruction Manual

ALLSPARES AS-FF140 Water Filter

Installation instructions

A replacement for the following water filters: Whirlpool° /Maytag°/ Amana° / KitchenAid° / JennAire filters
4396508, 4396508P, 439285l, 439285/R, 4396510, 4396510P, 4392922, 8212491, 2255520, SBSO02, SBSOO03, SBSO04, 481281729632, 4396918, 4396562, 4396563, 2200203, 2203220, 2203980, 2305766, 2305767, 2305768, 2255518, 2186444, PWF- NL240V, PNL240V, WF-NL240V, WFNL240V, NL240V, WF-NL240, WFNL240, NL240, WF- NL300, WFNL300, NL300, PWF-L400V, PL400V, WF-L400V, WFL400V, L400V, WF-L400, WFL400, L400, WF-L500, WFL500, L500, WF-300BR, Everydrop Filter 5, EDRSRXDI (ilter system that uses 4396508) KitchenAid filters 4396547, 43961 63, 4396509, 4396509P 4396546, 43961 64, 2203221, 2255709 Sears/Kenmore° filters 46-9902, 469902, 9902, 9902P, 04609902000, 46-9908, 469908, 9908, 9908P, 04609908000, 46-9010, 469010, 9010,9010P 04609010000

• Tested and Certified by NSF International against NSF/ANSI Standard 42 in model AS-FF140 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (s0.25% lead).

Before installation

• Shut off the cold-water supply to the refrigerator before installation. Turn on the refrigerator water dispenser to release water pressure, letting water drain from the pipe completely.

• It is normal for black carbon fines (particles) to appear on the outside of your filter. This happens when the filter is jarred in shipping. It is safe to simply wipe it off.

• The filter connectors are larger to prevent leaks. Yu might have to twist the filter hard to make sure the connection is secure.

  1. Locate filter below the refrigerator. Slowly turn the cartridge 1/4 turn counter-clockwise and remove knob from old filter.

  2. Remove all packaging, and remove the protective cap from the top

  3. Slide knob from old filter onto new filter. Insert filter into refrigerator and turn 1/4 turn clockwise until firmly seated.

  4. Dispense water into glass looking for good water flow. If flow is slow, remove and reinstall filter ensuring that the filter is a full 1/4 turn.
     Note: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours.

  5. Check filter one more time for any leaks.

  6. Run water from the dispenser for 5 minutes at 0.5 gpm (about 8L) to clear the system and prevent sputtering.

Resetting your filter indicator

Note: These are the most common filter reset instructions. If the instructions don’t work tor your refrigerator brand, see the documentation that came with your refrigerator.

Storage and maintenance

• Replace your filter every 6 months or 1100L to prevent bacteria and fungus growth in your fiter, supply lines, and storage tank.
• Keep your unused fiters ina cool, dark, and dry places until you need them.
• 1f do not use vour water dispenser for more than four days, run two gallons of water before using it to prevent bad-tasting water.

Frequently asked questions

QWhy i5 it difficult to twist the new ilter into the filter housing
A: The connector may expand because of water pressure. Therefore, it is recommended you push the new filter in with a little bit of force, but not too hard. Then turn it clockwise.

QDo Ineed to flush the filter after installation
A After installation, it is highly recommended you run the water tor a few minutes before using it. Water filters are made from advanced coconut carbon block, so there are some carbon fines in the filiter. Flushing removes the carbon fines to produce clean water

QMust the filter be changed every6 month?
A: Yes, you must replace the filter every six months or sooner if water flow is reduced or if there is heavy sediment rust present. Over-used filters will degrade the filtration performance.

Warning
To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions. This filter unit must be replaced every 1100L or 6 months. Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product Whirlpoo is a registered trademark of Whirlpool USA. Whirlpool is used for reference purposes only. KitchenAid Is a registered trademark of Whirlpool Properties, IN KitchenAid is used tor reference purposes only. Kenmore is a registered trademark of KCD IP, LLC. Kenmore has been used tor reference purposes only. The service life mentioned above is subject to chlorine reduction. The actual result varies according to the local water quality.

Operating specifications

• Operating Temperature: 33-100’F/0.6- 38°C
• Working Pressure: 20-100 psi140-689 kPa
• Rated Capacity: 300 gallons/1,1 37 litres
• Flow Rate: 0.5 gpm/1.9 lpm

Substance reduction
The system has been tested and certified by NSF International according to NSF/ANSI Standard 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the em was b CEIANCI Ce A vae advice system, as specified by NSF/ANSI Standard 42. Venice testing was performed under standard laboratory conditions, actual performance may very.

• Do not use water that is micro-biologically unsafe or of unknown water quality without adequate disinfection before or after the system. systems certiied tor cyst reduction may be used with disinfected water that may contain filterable cysts.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>