LIMENTE Mono-2 Power Dock with Independent Sliding Covers Instruction Manual
- June 9, 2024
- LIMENTE
Table of Contents
LIMENTE Mono-2 Power Dock with Independent Sliding Covers Instruction
Manual
CONTENTS
Cable mount plug
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTION
- To reduce the risk of electrical shock
- use only indoors.
- To reduce the risk of electrical shock
- disconnect power to the receptacle before installing or removing the unit.
- Do not attempt to open or repair the device yourself. There ore no user-serviceable ports inside.
- Do not plug in equipment thot exceeds the amperage rating indicated on the product’s label.
- This appliance must be connected to o main socket correctly installed and provided with ground connection in accordance with current norms.
- Do not use the product with extension cords or adapters that could eliminate its connection to ground.
- Do not use the product if the surrounding area is wet. If you have spilled liquid into theproduct (with open lids), disconnect the plug from the wall outlet and contact qualified personnel.
- Do not cover or place objects on or near that can block the functionality of the product.
INSTALLATION
Before proceeding, refer to the installation instructions and read carefully the safety precautions.
SAFETY PRECAUTIONS
Mount the plug on the cable
Warning: The installation of the plug and any connection to the main elec
ricity grid must be performed only by authorized personnel in compliance with
the current standards. 3
Warning: The product was designed to drain water that may be accidentally
spilled over (when the lids are closed), for this reason make sure that the
bottom side of the housing of the product is always free so that it con drain
the water inside.
Warning: Pay particular core during installation because the product is
not provided with a water collecting tray so should not be placed in areas
where the drained water below con cause damages.
Warning: If the product is mounted in areas at risk of contact with
water, it is necessary to apply silicone or similar sealants on the panel
where the frame stands. – Pay attention to position it far away from water
(min. 900 mm) if no silicone was applied around the frame.
MAINTENANCE
Clean the device with a soft dry cloth, No service or maintenance is required.
Do not attempt to disaassemble the device or the warranty may be voided.
WEEE
Waste of electric and electronic equipment
Products must be recycled properly and should not be disposed as household waste. Disposal in general household waste is prohibited.
SPECIFICATIONS
input voltage| Max.250V AC, 50-60| Degree of protection| IP 54 With closed
cover
---|---|---|---
Maximum load| Max. 16A| Operating environment|
Indoor
Maximum load| up to: 3400W| Dimensions (L x W x H)| 237x 66×42.5 mm
***** Follow the specifications listed on the product’s label. The specifics may vary, as the product is customizable by type of sockets.
The contents of this manual are for informational purposes only. All product dimensions and specifications are subject to change without notice.
WITH CLOSED COVERS
Limente – Helsinki www.limente.com