LIMENTE Mono-1 Electrical Outlet Instructions
- June 9, 2024
- LIMENTE
Table of Contents
LIMENTE Mono-1 Electrical Outlet
Instructions
Power dock with independent sliding covers
WITH CLOSED COVERS MED
CONTENTS
Allen Key
Cable mount plug
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
- To reduce the risk of electrical shock – use only indoors.
- To reduce the risk of electrical shock – disconnect power to the receptacle before installing or removing the unit.
- Do not attempt to open or repair the device yourself There are no user-serviceable parts inside.
- Do not plug in equipment that exceeds the amperage rating indicated on the product’s label.
- This appliance must be connected to a main socket correctly installed and provided with ground connection in accordance with current norms.
- Do not use the product with extension cords or adapters that could eliminate its connection to ground.
- Do not use the product if the surrounding area is wet. If you have spilled liquid into the product (with open lids), disconnect the plug from the wall outlet and contact qualified personnel.
- Do not cover or place objects on or near that can block the functionality of the product.
INSTALLATION
Before proceeding, refer to the installation instructions and read carefully the safety precautions.
SAFETY PRECAUTIONS
Mount the plug on the cable
- Warning: The installation of the plug and any connection to the main electricity grid must be performed only by authorized personnel.
- Warning: The product was designed to drain water that may be accidentally spilled over (when the lids are closed), for this reason make sure that the bottom side of the housing of the product is always free so that it can drain the water inside.
- Warning: Pay particular care during installation because the product is not provided with a water collecting tray so should not be placed in areas where the drained water below can cause damages.
- Warning: If the product is mounted in areas at risk of contact with water, it is necessary to apply silicone or similar sealants on the panel where the frame stands.
- Pay attention to position it far away from water (min. 900 mm) if no silicone was applied around the frame.
Tighten without applying too much force.
MAINTENANCE
Clean the device with a soft dry cloth. No service or maintenance is required. Do not attempt to disassemble the device or the warranty may be voided.
WEEE
Waste of electric and electronic equipment.
Products must be recycled properly and should not be disposed as household
waste.
Disposal in general household waste is prohibited.
The contents of this manual are for informational purposes only.
All product dimensions and specifications are subject to change without
notice.
SPECIFICATIONS
Follow the specifications listed on the product’s label.
The specifics may vary, as the product is customizable by type of sockets.
Limente –
Helsinki
www.linmente.com