dji AC002 OSMO ACTION 3 Outdoor Action Camera User Guide
- June 9, 2024
- DJi
Table of Contents
dji AC002 OSMO ACTION 3 Outdoor Action Camera
SAFETY AT A GLANCE
WARNING
- OsmoTM Action 3 contains magnets. Keep the camera unit away from magcards, IC cards, hard disks, RAM chips, implantable medical devices such as pacemakers, and other devices to avoid interference.
- Clean the battery, lens, lens protective cover, and the USB-C cover with a clean, dry cloth. Otherwise, Osmo Action 3 may no longer be waterproof. All the holes on Osmo Action 3 have built-in waterproof material. DO NOT poke the holes.
- Follow the instructions in the user manual to make sure the battery is mounted, the USB-C cover is closed, and the lens protective cover is properly tightened. Make sure Osmo Action 3 is dry before removing the battery.
- If the battery falls into water, put it in a safe and open area immediately. Maintain a safe distance from the battery until it is completely dry. DO NOT use the battery again, and properly dispose of the battery as described in point 30.
- Put out a battery fire using water, sand, a fire blanket, or a dry powder fire extinguisher.
- DO NOT use a non-DJI OSMO battery. DJI OSMO takes no responsibility for any damage caused by a non-DJI OSMO battery. Purchase a new battery at www.dji.com.
- DO NOT use or charge swollen, leaking, or damaged batteries. If the battery is abnormal, contact DJI OSMO for further assistance.
- The battery should be used at a temperature between -4° to 113° F (-20° to 45° C). Use of the battery in an environment above 113° F (45° C) can lead to a fire or explosion. Before using the battery in a low-temperature environment, it is recommended to charge the battery fully in a normal temperature environment. Charging the battery at the ideal temperature can prolong battery life.
- DO NOT use the battery in a strong electrostatic or electromagnetic environment. Otherwise, the circuit board may malfunction.
- DO NOT disassemble or pierce the battery in any way. Otherwise, the battery may leak, catch fire, or explode.
- DO NOT drop or strike the battery. DO NOT place heavy objects on the battery or charger.
- Electrolytes in the battery are highly corrosive. If any electrolytes make contact with your skin or eyes, immediately wash the affected area with fresh running water for at least 15 minutes, and then see a doctor immediately.
- DO NOT use the battery if it is dropped or impacted in any way.
- DO NOT heat the battery. DO NOT use a hairdryer to dry the battery or put the battery in a microwave oven or a pressurized container.
- DO NOT place loose battery cells on any conductive surface, such as a metal table.
- DO NOT manually short-circuit the battery.
- DO NOT attach the battery to a power outlet or car charger socket directly. The battery must be charged through Osmo Action 3 or the Osmo Action 3 Multifunctional Battery Case. DJI OSMO takes no responsibility if the battery is charged using a non-DJI OSMO charger.
- DO NOT charge the battery near flammable materials or on flammable surfaces such as carpet or wood. DO NOT leave the battery unattended during charging.
- DO NOT charge the battery immediately after use, as the battery temperature may be too high.
- DO NOT charge the battery until it cools down to near room temperature. Charging the battery outside the temperature range of 41° to 104° F (5° to 40° C) may lead to the battery leaking, overheating, or long-term damage.
- Disconnect the charger when not in use. Examine the charger regularly for damage to the cord, plug, and other parts of the charger. DO NOT clean the charger with denatured alcohol or other flammable solvents. DO NOT use a damaged charger.
- Keep the battery out of the reach of children and animals.
- DO NOT leave the battery near heat sources such as a furnace or heater. DO NOT leave the battery inside of a vehicle on hot days. DO NOT store the battery in environments with a temperature higher than 60° C (140° F). The ideal storage temperature is between 22° to 28° C (71.6° to 82.4° F).
- Store the battery in a ventilated location and keep the battery dry.
- Store the Osmo Action 3 in a ventilated place and keep the battery dry to prevent condensation on the camera lens. It is recommended to store the camera in an environment with humidity lower than 40%.
- DO NOT store a fully discharged battery for an extended period. Otherwise, it will over discharge, which will lead to permanent damage to the battery.
- Before taking a battery on an airline flight, fully discharge the battery. Make sure to discharge the battery in a fireproof location.
- Keep the battery away from metal objects such as glasses, watches, jewelry, and hairpins.
- DO NOT transport a damaged battery or a battery with a power level higher than 50%.
- Only dispose of a battery after completely discharging it. DO NOT dispose of a battery in a regular trash container. Strictly follow your local regulations regarding the disposal and recycling of the battery.
SPECIFICATION
- Model AC002
- WIFI Operating frequency
- Operating frequency: 2.4000-2.4835 GHz, 5.150-5.250 GHz, 5.725-5.850 GHz
- EIRP: 2.4G< 17dBm; 5G<16dBm
- Bluetooth 2.4000-2.4835 GHz; Eirp<4dBm; BLE5.0 1M,2M;
- Type C port
- Input: 5-9V⎓ 3A Max
- Max transmission rate: 480Mbps
- Operating temperature -20°C-45°C
APP
FUNCTION AND DESCRIPTION
FITTING
Compliance Information
FCC Compliance Notice
Supplier’s Declaration of Conformity
Product name: Osmo Action 3
Model Number: AC002
Responsible Party: DJI Technology, Inc.
Responsible Party Address: 201 S. Victory Blvd., Burbank, CA 91502
Website: www.dji.com
We, DJI Technology, Inc., being the responsible party, declares that the above
mentioned model was tested to demonstrate complying with all applicable FCC
rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body and head These requirements set a SAR limit of 4W/kg averaged over ten grams of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the limbs.
ISED Compliance Notice
CAN ICES-003 (B) / NMB-003(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference.(2)This device must accept any interference,
including interference that may cause undesired operation of the device.
This equipment complies with RSS‐102 radiation exposure limits set forth for
an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.The portable device is designed to meet the requirements for
exposure to radio waves established by the CNR‐102.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value reported under this standard during product
certification for use when properly worn on the body and head. These
requirements set a SAR limit of 4W/kg averaged over ten grams of tissue. The
highest SAR value reported under this standard during product certification
for use when properly worn on the limbs.
The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems.
EU Compliance Statement: SZ DJI Osmo Technology Co., Ltd. hereby declares
that this device (OSMO ACTION 3) is in compliance with the essential
requirements and other relevant provisions of the Directive 2014/53/EU. A copy
of the EU Declaration of Conformity is available online at www.dji.com/euro-
compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer,
Germany
UK Compliance Statement: SZ DJI Osmo Technology Co., Ltd. hereby,
declares that this device (OSMO ACTION 3) is in compliance with Radio
Equipment Regulations 2017. The full text of the UKCA declaration of
conformity is available at the following internet address: www.dji.com/euro-
compliance
GB Compliance Statement: SZ DJI Osmo Technology Co., Ltd. hereby declares
that this device (OSMO ACTION 3) is in compliance with the essential
requirements and other relevant provisions of Radio Equipment Regulations
2017.
A copy of the GB Declaration of Conformity is available online at www.dji.com
/euro-compliance
Environmentally friendly disposal
Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.
This device is restricted to indoor use when operating in the 5150-5250MHz frequency range in all EU/EFTA member states, Turkey and UK.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
To view the full compliance information , side down on the camera view, tap the setting icon ,and scroll through to select Compliance info.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>