APC SMC 3000 Series VA 230 Vac Tower Smart UPS Installation Guide
- June 9, 2024
- APC
Table of Contents
Installation Guide Smart-UPS™
SMC 1000/1500/2000/3000 VA 230 Vac
Tower
Important Safety Messages
Read the instructions carefully and look at the equipment to become familiar
with the device before trying to install, operate, service or maintain it. The
following special messages may appear throughout this document or on the
equipment to warn of potential hazards or to call attention to information
that clarifies or simplifies a procedure.
The addition of this symbol to a Danger or Warning product safety label
indicates that an electrical hazard exists that will result in personal injury
if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal
injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
NOTICE is used to address practices not related to physical injury.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.
- Adhere to all national and local electrical codes.
- All wiring must be performed by a qualified electrician.
- Changes and modifications to this unit not expressly approved by APC could void the warranty.
- This UPS is intended for indoor use only.
- Do not operate this unit in direct sunlight, in contact with fluids, or where there is excessive dust or humidity.
- Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.
- For a UPS with a factory installed power cord, connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.
- The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment
- The batteries are heavy. Remove the batteries before installing the UPS and external battery packs (XLBPs), in a rack.
Battery safety
-
The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten battery life. The battery should be replaced before end of life.
-
APC by Schneider Electric uses sealed lead acid batteries. Under normal use and handling, there is no contact with the internal components of the battery. Over charging, over heating or other misuse of batteries can result in a discharge of battery electrolyte. Released electrolyte is toxic and may be harmful to the skin and eyes.
-
Replace the battery immediately when the UPS indicates battery replacement is necessary.
-
The UPS will recognize as many as 10 external battery packs connected to the UPS.
Note: For each XLBP that is added, increased recharge time will be required. -
CAUTION: Before installing or replacing the batteries, remove jewelry such as wristwatches and rings. High short circuit current through conductive materials could cause severe burns.
-
CAUTION: Do not dispose of batteries in a fire. The batteries may explode.
-
CAUTION: Do not open or mutilate batteries. Released material is harmful to the skin and eyes and may be toxic.
General information
- The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel.
- Always recycle used batteries.
- Recycle the package materials or save them for reuse.
Radio Frequency Warning
This product has been tested and found to be category C2 device. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment is likely to cause radio interference with some communication devices like TV, mobiles, audio equipments, radio receivers, etc. Generally this issue can be corrected by moving the equipment a little away from the UPS, however sometimes additional measures may have to be taken at user’s expense.
Package Contents
Front Panel Features
- Online/On Battery LED
- POWER ON/OFF button
- Site Wiring Fault/System Alert LED
- Display interface
- DISPLAY button
- MUTE button
Rear Panel Features
3000 VA models
- USB port
- Serial data port
- Battery connector
- Circuit breaker/Overload protection
- UPS input
- Outlets
- Chassis ground screw
Installation
CAUTION
RISK OF ELECTRIC SHOCK
- Adhere to all local and national electrical codes.
- Wiring must be performed by qualified electrician.
- Always connect the UPS to a grounded outlet.
- Always connect ground wires between the UPS and the external battery packs.
Failure to follow these instructions could result in minor or moderate injury.
Connect the Battery Connect equipment to the UPS and connect the UPS to
utility power
CAUTION
RISK OF ELECTRIC SHOCK
- Adhere to all local and national electrical codes.
- Wiring must be performed by qualified electrician.
- Always connect the UPS to a grounded outlet.
Failure to follow these instructions could result in minor or moderate injury.
© 2017 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned
by Schneider Electric Industries S.A.S., or their affiliated companies. All
other trademarks
are property of their respective owners.
Smart-UPS™ C 1000/1500/2000/3000
VA 230 Vac Tower
Documents / Resources
| APC
SMC 3000 Series VA 230 Vac Tower Smart
UPS
[pdf] Installation Guide
SMC 1000, SMC 1500, SMC 2000, SMC 3000, SMC 3000 Series VA 230 Vac Tower Smart
UPS, VA 230 Vac Tower Smart UPS, Vac Tower Smart UPS, Tower Smart UPS
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>