TAP KP-55 Acoustic Guitar Owner’s Manual
- October 29, 2023
- TAP
Table of Contents
KP-55 Acoustic Guitar
Owner’s Manual
Piezo ceramic pickup ( UST ) for ACOUSTIC GUITAR with distance of strings (55mm). Every piezo pickup constructed with separate ceramic element’s and skillfully assemble with great precision, That improving the balance between strings. Excellent frequency response characteristic and natural sound reproduction. Perfectly you can combine this with PRE-PZ external preamplifier and also with ENJ preamplifier built-in on endpin jack.
INSTALLATION INSTRUCTION
-
Remove the strings, bridge pins, the saddle and the strap button pin Check the UST that it fits into the saddle slot easily. Do not cause, improper pressure on the piezo pickup. The saddle slot must be a minimum of 4,5 mm deep for the entire length of the slot.
-
Drilling the hole for UST
Drill a preferably 2 5mm hole for the cable into the one end of the saddle slot. It is preferred at the suing side low-E. -
Drilling the hole for Endpin Jack Put a piece of masking tape where the hole will he drilled,
Use a small drill bit to make a staler hole and then finish by using the 12mm drill bit. Smooth the edge of the hole. -
Install the piezo pickup and bring the wire through the hole and then bring the wire to the endpin hole.
-
Solder the shield wire to the outside leg of your output jack and the center conductor wire to the center pin
-
Put the endpin jack with the connected cable into the hole and push the jack inside as wedge.
-
Reinstall the saddle. the strings and make necessary adjustments in your instrument. Tune your guitar
TIP. We recommend that a professional should do this procedure.
Certainly if the saddle slot needs be deepened, only an experienced craftsman
should make the adjust.
https://www.tap.com.gr/en/products/guitar/kp-55-detail.html