TAP PIEZO AUD Piezo Ceramic Bar is Fitted Into AUD Instruction Manual
- June 9, 2024
- TAP
Table of Contents
Piezo
A UD
INSTALLATION INSTRUCTIONS
A UD piezo pickup bar is made under high precision tests. For safe installation remove strings and make a slot on the bridge with adequate width for the piezo (2.5 mm) and a depth of (5 mm) at least. Never push hard piezo to be in place because damage may occur. Drill a hole ( 2,3mm ) to the end of the slot for the cable. Also drill a ( 12 mm ) hole for output jack installation. Put pickup in slot and pass the cable from the bridge hole of 2,3mm and then through the 12 mm hole: Solder the central wire of the pickup cable to the central pin of the jack. Solder the shield of the cable to the outside leg of the jack. Secure the cable properly. Then create carefully a right saddle for the piezo and put it over into slot. Put strings in place and tune.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>