ENGO CONTROLS EIRTXWIFI Wi-Fi IrDA Transmitter User Guide

ENGO CONTROLS EIRTXWIFI Wi-Fi IrDA Transmitter

INTRODUCTION

EIRTXWIFI is a universal product that can replace a traditional remote control. It allows you to conveniently control various infrared receiving devices, such as TV, decoder, air conditioner, etc. It supports local and remote control of devices. In addition, using the ENGO Smart mobile app, you can create scenes to, for example, automatically turn on/off the TV or air conditioner (only when Wi-Fi is available).

Product Compliance

This product complies with the following EU Directives: 2014/53/EU, 2016/65/EU

Technical specification

Device application with the ENGO APP and devices

EIRTXWIFI installation

Warning!

Connect the EIRTXWIFI remote control to a 230V AC power supply, use the supplied plug and USB cable only.
The remote control must be placed in the same room as the controlled devices. EIRTXWIFI sends an infared signal – lack of architectural barriers is required for proper control of the devices.

Explanation for LED indicator

holding the Reset button (10 sec.)

LED is off

|

1. The device is connected to the Internet
2. No power supply

|

1. Normal work mode
2. Connect the device to a power supply

LED lights up|

1. The device is not connected to the Internet
2. The device is in learning mode

|

1. Check network connection quality or if the router is connected correctl
2. When the device is correctly connected to the network, it goes into learning mode. When the process is successful, the yellow LED will turn off

Installation of the IR remote control in the APP

Make sure your router is within range of your smartphone. Make sure you are connected to the Internet. This will reduce the pairing time of the device.

STEP 1 – DOWNLOAD ENGO SMART APP

Download the ENGO Smart app from Google Play or Apple App Store and install it on your smartphone.

| |
---|---|---
|

STEP 2 – REGISTER THE NEW ACCOUNT

To register a new account, please follow the steps below:

1. Click „Register” to create new account.
   

2. Enter your e-mail address to which the verification code will be sent.
   

3. Enter the verification code received in the email.
   Remember that you only have 60 seconds to enter the code!

4. Then set the login password.

STEP 3 – CONNECT THE IR REMOTE CONTROL TO WI-FI

After installing the app and creating an account:.

1. Turn on Wi-Fi and Bluetooth on your smartphone. It’s best to connect mobile to the Wi-Fi network to which you want to assign the device.
   

2. Make sure the device is powered on. Using the PIN included, press and hold the RESET button for 8 seconds until LED starts flashing. The pairing mode is enabled.
   

3. In the app, select: „Add Device”.

4. Then choose: „Auto Scan”.

5. After finding the thermo- stat, go „Next”.

6. Select the Wi-Fi network in which the thermostat will operate and enter the password of this network.

7. Wait for the app to configure the thermostat with the selected Wi-Fi network.
   

8. Name the device and click „Done”
   

9. You can then pair up any device that supports infrared remote control. Click „Add”.
   

10. Choose the device type which you want to connect the IR remote control with.
    

11. Choose „Quick match”.

12. Find the device brand from the list and follow further instructions.
    

Reset of the remote control

To restore the default settings of the device, press RESET button and hold it for about 10 seconds – until the LED lights up. The IR remote control will then reset to the default (factory) settings and the pairing process will begin.

CUSTOMER SUPPORT

www.engocontrols.com

References

• ENGO Controls - Sterowanie ogrzewaniem

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>