marta MT-4265 Electric Oven User Manual

: June 9, 2024
: MARTA

Table of Contents

Parts list
USING THE APPLIANCE
CLEANING AND MAINTENANCE
SPECIFICATION
Documents / Resources

marta MT-4265 Electric Oven User Manual

Parts list

Housing
Door with handle
Temperature control knob
Operation indicator light
Operating mode selection knob
Timer setting knob
Rotisserie and handle for removing
Bake tray
Wire rack
BBQ forks
Handle for removing the bake tray / Wire rack
Crumb tray

CAUTION

Read this manual carefully before using the appliance and save it for future reference. When using electrical appliances, basic precautions should always be followed, including the following:

The appliance is designed for domestic cooking and heating only in accordance with these operating instructions.
Before the first use, check the device specifications and the power supply in your network. Use the appliance only on the voltage specified on the identification plate.
The device must always be connected to a grounded socket.
It is not intended for industrial use.
Use the device in a well ventilated room with at least 15 cm. space on each side for normal air circulation and heat removal.
Do not allow the operating device to come into contact with fusible or flammable materials, fabrics, curtains, etc.
For indoor use only. Use only for domestic purposes according to the instruction manual. Do not use or store the unit in damp and moist areas where it may come in contact with water.
Do not place or use the unit on or near other household appliances (a hot gas or electric burner, etc.)
Do not use the appliance near explosives or flammable materials.
Do not use with damaged cord, plug or other injuries. Do not move the device by holding the cord.
Keep the power cord away from sharp edges and hot surfaces. Do not pull the cord. Always take the socket not the wire. Do not reel the cord around the device housing.
Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.
Excessively large products, vacuum-packaged products, cardboard, paper, plastic wrapping/ware/baking moulds must not be cooked in the appliance as this can cause a fire.
Do not heat oil in the appliance. Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
Place the appliance on a flat, stable and heat-resistant surface that can support the weight of the appliance with food and cooking utensils.
Incorrectly assembled device may cause fire, electric shock or other injury.
DANGER: Do not cover the device with anything while it is in operation! Do not place any objects on it!
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
Do not touch the appliance, the power cord and the plug with wet hands!
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Keep out of the reach of children. Close supervision is necessary when this appliance is to be used by or near children.
Do not switch on an empty device without food for more than 15 minutes.
Maximum allowable continuous operating time is 4 hours.
Do not allow products to come into contact with heating elements.
Keep water away from hot glass as it may crack.
Do not physically expose the door or glass – do not place any objects or lean on it.
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
WARNING: This device heats up during use. The temperature of the door or other surfaces may be exceeded when the appliance is in operation. Do not touch the hot surfaces or heating elements inside to avoid burns. Use special accessories, kitchen tackles or mittens.

WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty service

BEFORE THE FIRST USE

Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.
Make sure that there are no packaging materials or foreign objects (including products) inside.
Switch on all heating elements by selecting heating mode ,set the maximum temperature to 230°C and timer for 15 minutes. Some smoke or odour may be produced at the first switch-on, this is normal and not a malfunction. At the end of this cleaning procedure, let the unit cool down, after which it will be ready for operation.

USING THE APPLIANCE

SWITCHING ON

Make sure the device is switched off (timer adjustment knob is in the «OFF/0» position). Connect the device to the power supply.
Install a bake tray and/or wire rack, place the food. If the food is cooked on the wire rack/skewer/rotisserie, place the bake tray on the bottom level to prevent oil/grease/juice droplets from getting onto the heated surfaces.
Turn the temperature adjustment knob “3” to set the desired temperature from 100 to 250°C.
Then turn the heating mode selection knob “5” to set desired heating mode.
The rotation of the skewer/rotisserie is activated automatically when the operation mode of the upper heating elements or the upper + lower ones, is selected.
To turn on the device, set the timer from 1 to 60 minutes by turning the timer setting knob “6”.
The inner light and indicator light “4” will illuminate, the device starts working.
After the set time has elapsed, an audible signal will sound, the inner light & indicator light will go out, and the device will stop working. If the products are not ready yet, set the additional operating time by turning the timer knob. In order to get better cooking performance, it is recommended to pre heat the oven about 10-15 minutes. DO NOT USE THE APPLIANCE MORE THAN 4 HOURS WITHOUT A BREAK.

HEATING MODE SELECTION

To set the desired heating mode, turn the heating mode adjustment knob “5” to one of the following positions:

the upper heating elements & rotation of the skewer/rotisserie.
the upper & lower heating elements & rotation of the skewer/rotisserie.
the lower heating elements operating mode
all heating elements & operating modes are off.

USING THE ROTISSERIE

Loosen the clamps on the retainers.
Attach one retainer to the rod of the rotisserie, insert the rod through the product you are going to cook, place the food in the center of the rotisserie, and attach the second retainer. Make sure that the clamps are twisted and the impaled product is firmly fixed on the rotisserie. Do not allow the product parts to come into contact with the heating elements!
Set the rotisserie with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.
Set the desired temperature, then choose desired cooking modes by turning the knob “5” and set the timer.
To avoid burns, use the supplied handle “7” and gloves (not included) to install and remove the skewer or the rotisserie.
To remove the skewer or the rotisserie, first lift the left side of the skewer so that it comes out of the slot holder, then remove the right side.

USING THE SKEWER

Loosen the clamps on the retainers.
Thread the rod through the square holes in the skewer (parallel to the shapruram).
Tighten the clamps.
Skewer the product you are going to cook.
Set the skewer with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.
Set the desired temperature, then choose desired cooking modes by turning the knob “5” and set the timer.
To avoid burns, use the supplied handle “7” and gloves (not included) to install and remove the skewer or the rotisserie.
To remove the skewer or the rotisserie, first lift the left side of the skewer so that it comes out of the slot holder, then remove the right side.

SWITCHING OFF

The device will automatically turn off when the time set on the timer expires.
The device can be switched off at any time by turning the heating mode adjustment, temperature adjustment and timer knobs to the “OFF” position. An audible signal will sound, the light indicator will go out, the device will stop working.
WARNING: Always turn off the unit when cooking is finished.
Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug. Always allow the appliance to cool down completely before you put it away.

CLEANING AND MAINTENANCE

Before cleaning, always unplug the appliance.
Use wet cloth to clean the device. Do not immerse the appliance in water or other liquids.
Clean accessories in soapy water and dry.
Do not use chemical and abrasive cleaners for cleaning.
Recommended to clean the device right after operating.

SPECIFICATION

Power supply| Power, W| Capacity, L| Net weight / Gross weight, kg| Package size (L х W х H), mm
---|---|---|---|---
230 V ~ 50 Hz| 2000| 30| 7,0 / 8,1| 533 х 372 х 357

Producer

COSMOS FAR VIEW INTERNATIONAL LIMITED Room 701, 16 apt, Lane 165, Rainbow North Street , Ningbo, China Made in China

WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.

MT – 4265

marta Logo