Clinton Electronics CPSM Swivel Mount for Telescoping Camera Poles Installation Guide
- June 9, 2024
- Clinton Electronics
Table of Contents
CE-CPSM(B) Install Guide
CPSM Swivel Mount for Telescoping Camera Poles
Included Items:
- CE-CPSM(B) Swivel Mount
- Mounting Hardware
- 3/16” Allen Wrench
- Safety Cable
- Instructions
Required Items:
- 7/16” Crescent Wrench
- 9/16” Crescent Wrench or Pliers
CAUTION! USE ONLY AS DESIGNED. THIS PRODUCT IS DESIGNED TO SERVE AS A SWIVELING APPARATUS TO BE USED IN CONJUNCTION WITH A CAMERA POLE MOUNT. IT IS INTENDED FOR USE ONLY WITH THE MAXIMUM WEIGHT INDICATED. USE WITH PRODUCTS HEAVIER THAN THE MAXIMUM WEIGHTS INDICATED MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.
NOTICE Not compatible with 17ft Telescoping Camera Poles. This Swivel Mount Bracket is only compatible with 3ft, 6ft, and 12ft Telescoping Camera Pole models.
**Maximum Load Capacity: 10 Ibs / 4.5 kgs **
-
DISASSEMBLE CAMERA POLE
Using a 3/16” Allen wrench and 7/16” Crescent wrench, remove the top mounting head from the camera pole. Discard this mounting head and hardware- it is not needed when using the Swivel Mount.
-
INSERT BOLT
Insert the 4” long 3/8-16 bolt into the top hole of the Box Bracket. -
INSERT BALL
Insert the Swivel Ball into the Box Bracket. -
INSERT POLE
Insert the camera pole into the bottom hole of the Swivel Ball.
NOTICE Not compatible
with 17ft Telescoping Camera Poles. -
ATTACH SAFETY CABLE & BOLT
Align one eyelet of the safety cable to the round hole side in the Swivel Ball.
(The Hexagon hole side of the Swivel Ball will be used in step #7)
Insert the 1/4-20 Allen bolt through the Safety Cable eyelet, Swivel Ball, and the camera pole.
NOTE: Leave the opposite side of the safety cable, and the lock nut off until mounted to ceiling structure.
-
ATTACH TO STRUCTURE
Insert the top bolt through a hole or gap in the ceiling support structure.
NOTE: Align the mount so that the Safety Cable can loop over the ceiling support structure.
Attach the top fender washer, and secure the top lock nut with a 9/16” Crescent Wrench or Pliers.
-
SECURE SAFETY CABLE
With the Safety Cable looped over the ceiling support structure, push the eyelet of the Safety Cable into the hexagon shaped hole.
Press the lock nut into the hexagon shaped hole while pushing and turning the Allen head bolt on the opposite side.
Tighten the Allen head bolt with the 3/16” Allen wrench.
clintonelectronics
6701 Clinton Road Loves Park, IL 61111
800.549.6393 (Support)
www.clintonelectronics.com
*Information in this document is subject to change without notice
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>