FRANKE DROP SLIM II Kitchen Extractor Hood Instruction Manual

June 9, 2024
Franke

FRANKE DROP SLIM II Kitchen Extractor Hood

DROP SLIM II Kitchen Extractor Hood

Parts

Parts

Package Content

Package Content
Package Content

Diminution

Diminution Diminution
Diminution
Diminution
Diminution

Installation Instructions

Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions

Installation

  • Make sure that the installation is carried out only by specifically trained and qualified personnel.
  • During installation observe the applicable regulations concerning exhaust air.
  • Mount the device only with suitable fixing material.
  • Make sure that damaged cables are changed by the manufacturer or the customer service.

Mounting location

  • Make sure that the kitchen has an opening to the outside to ensure a sufficient air exchange.
    If the hood is used along with devices that do not require electricity:

  • Make sure that the negative pressure in the room does not exceed 0.04 mbar to ensure that the exhaust gases will not be drawn in again.

Spacing

  • Observe the safety distance between stove top and hood.
    If the installation instructions for a gas-powered stove top require a greater distance than specified in these installation instructions:

  • Observe the specifications of the gas-powered stove top.

Connecting the smoke vent

  • Do not connect the hood to a shaft that is used for flue gas (e.g. from a fireplace, heating system etc.).
  • Connect the hood to the smoke vent with a pipe and make sure that the route of the pipe is as short as possible.
  • If gas-powered devices or similar devices that do not require electricity are used in the same room as the hood: Ensure a sufficient ventilation to avoid the backflow of exhaust gases.

Electrical connection

  • Observe the supply voltage (see type plate).
  • For devices of class I: Make sure that the power grid in the building is earthed correctly.
  • Connect the hood to the mains power supply with a double-pole switch with a contact gap width of at least 3 mm.

United Kingdom
Franke UK Ltd.
Manchester M22 5WB
Phone +44 161 436 6280
www.franke.com

Documents / Resources

| FRANKE DROP SLIM II Kitchen Extractor Hood [pdf] Instruction Manual
DROP SLIM II Kitchen Extractor Hood, DROP SLIM II, Kitchen Extractor Hood, Extractor Hood
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals