tp-link TL-SF1016D 10-100 Mbps Desktop Switch Installation Guide
- June 9, 2024
- tp-link
Table of Contents
tp-link TL-SF1016D 10-100 Mbps Desktop Switch Installation Guide
LED Explanation
Power
On: Power on
Off: Power off
Link/Act
On: Link present but no activity
Flashing: Transmitting/receiving data
Off: No link
Connection
Frequently Asked Questions (FAQ)
Q1. The Power LED is not lit.
The Power LED should be lit when the power system is working normally. If the
Power LED is not lit, please check as follows: A1: Make sure the power cord is
connected to the switch with power
source properly. A2: Make sure the voltage of the power supply meets the
requirements of the input voltage of the switch. A3: Make sure the power
source is ON.
Q2. The Link/Act LED is not lit when a device is connected to the corresponding port.
It is recommended that you check the following items: A1: Make sure that the
cable connectors are firmly plugged into the
switch and the device. A2: Make sure the connected device is turned on and
working well. A3: The cable must be less than 100 meters long (328 feet).
Specifications
General Specifications
http://www.tp-link.com/support
To ask questions, find answers, and communicate with TP-Link users or engineers, please visit https://community.tp-link.com to join TP-Link Community.
For technical support and other information, please visit https://www.tp- link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides, welcome to email techwriter@tp-link.com.cn.
Environmental and Physical Specifications
Operating Temperature 0°C to 40°C (32°F to 104°F)
Operating Humidity 10% to 90%RH non-condensing
Storage Humidity 5% to 90%RH non-condensing
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863. The original EU
declaration of conformity may be found at https://www.tp-link.com/en/ce.
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
- Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Adapter shall be installed near the equipment and shall be easily accessible.
- Place the device with its bottom surface downward.
- Use only power supplies which are provided by manufacturer and in the origin packing of this product. If you have any questions, please don’t hesitate to contact us.
References
- 域名售卖
- TP-Link Community
- CE Regulatory Compliance | TP-Link
- TP-Link Product Support - Wireless Networking Equipment Support