HyperX Alloy Origins 60 User Guide
- June 9, 2024
- HYPERX
Table of Contents
HyperX Alloy Origins 60
Keyboard Overview
- A HyperX Alloy Origins 60 keyboard
- B Adjustable keyboard feet
- C USB-C port
- D Keycap puller
- E Accessory keycaps
- F USB cable
Installation
Function keys
Press “FN” and a function key at the same time to activate its secondary
feature as indicated on the keycap side-print.
HyperX NGENUITY Software
To customize lighting, Game Mode, and macro settings, download the HyperX
NGENUITY Software at
hyperxgaming.com/ngenuity
Questions or Setup Issues?
Contact the HyperX support team at
hyperxgaming.com/support/keyboards
FCC
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correct the interference by one or more of
the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be speciffied in the
instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord be
used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment
HyperX is a division of Kingston.
THIS DOCUMENT SUBJECT TO CHANGE WITHOUT NOTICE
©2021 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley,
CA 92708 USA.
All rights reserved. All registered trademarks and trademarks are the property
of their respective owners.
Kingston Technology Europe Co LLP, Kingston Court, Brooklands Close,
Sunbury–on–Thames, Middlesex, TW16 7EP, UK. Kingston
Technology International Ltd, Stratus House, College & Business Technology
Park, Blanchardstown Road North, Dublin, D15 PEC4, Ireland
Kingston Technology Far East Corp.