TAP STICK-3 Guitar Aud Instruction Manual
- June 9, 2024
- TAP
Table of Contents
TAP STICK-3 Guitar Aud
FEATURES
Exceptional and flexible, triple sensor-transducer (contact microphone). The 3
sensors takes the vibrations directly from the musical instruments body and
reproduces clean and undistorted sound. Using the triple sensor arrangement,
is attributed the best sound effect with full balanced harmonics. That can
satisfying even the most demanding player. Comes with high output signal for
connection on amplifier or console. Suitable for Guitar, Santur, Dulcimer,
Aud, etc.
Technical Information
- Sensor height: 1,4 mm
- Sensor diameter: 12 mm
- Impedance: High ohmic
Internal Installation
Before installing the STICK—3 must cleaning the instrument surface. After that, easy mount the sensor with the double adhesive tape. For removing the sensor, keep firmly with fingers around the diameter and pull out carefully – slowly. For reinstallation, spare parts of double adhesive tape included. Comes with Endpin jack. Drilling the hole for Endpin Jack.
- Put a piece of masking tape where the hole will be drilled. Use a small drill bit to make a starter hole and then finish by using the 12 mm drill bit.
- Put the endpin jack with the connected cable through the sound hole into the guitar.
- Adjust the endpin jack by using the inside nut and secure with external nut.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>