DCWeditions Tell Me Stories Wall Sconce Instruction Manual
- June 9, 2024
- DCWeditions
Table of Contents
DCWeditions Tell Me Stories Wall Sconce
IN THE BOX
| |
---|---|---
REQUIRED TOOLS
WARNING
The safety of this fixture is only guaranteed if the instructions have been
observed. — Always disconnect power before working on fixture. — Fixture must
not be installed in any position other than that shown in instructions. —
Assembly and maintenance of fixture must be performed carefully so as not to
damage components. — Replacement bulbs must be of same type and wattage as
specified in instructions. — Metal surfaces, glass or other parts of fixture
may be cleaned with a soft damp cloth and mild detergent.
—
DCW ÉDITIONS will replace merchandise with manufacturing defects only if it is
returned to the retailer from which it was purchased. — If you are unsure
about your wiring, please consult a qualified electrician. The damaged cables
should be changed by manufacturer or distributor or qualified electrician. —
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person.
This product contains a light source of energy efficiency class X (LED Source
- and a light source of energy efficiency class X (LED Source 2) — Do not
dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
OVERVIEW
LED SOURCE 1
Replaceable (LED only) light source by a professional.
LED SOURCE 2
Replaceable (LED only) light source by a professional.
Replaceable control gear by a professional.
DIMENSION
STEP 1
Mark then make holes in the wall with a Ø7 diameter. The plate and the invisible hook have a center distance of 708mm.
ASSEMBLE INSTRUCTIONS
STEP 2
Screw the plate as well as the invisible hook
STEP 3
Connect electric wires
STEP 4
Lock the lamp on the plate with the 2 provided screws
STEP 5
Lock the lamp on the invisible hook with the headless screw
STEP 6
Assemble the 2 mirrors as well as the two discs on the central shaft. If you
use the disks as tablets, check that they are level.
