zelmer ZKR1300B Stand Mixer User Manual
- June 9, 2024
- zelmer
Table of Contents
ZKR1300B Stand Mixer User Manual
ZKR1300B Stand Mixer
WE WOULD LIKE TO THANK YOU FOR CHOOSING ZELMER. WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT.
STORE THESE IN A SAFE PLACE FOR FUTURE REFERENCE
DESCRIPTION
- Output shaft
- Rise button
- Speed button
- Bowl
- Dough hook
- Beater
- Whisk
- Bowl cover
SAFETY INSTRUCTIONS
If the supply cord is damaged it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Respect the operating times of the accessories indicated in their specific
sections of the manual.
Proceed according to maintenance and cleaning section of this manual for
cleaning.
Warning: potential injury from misuse!
Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
Switch off the appliance and disconnect from supply before changing
accessories or approaching parts that move in use.
This appliance shall not be used by children. Keep the appliance and its cord
out of reach of children.
Appliances can be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and
if they understand the hazards involved.
Children shall not play with the appliance.
This appliance is intended for use at a maximum altitude of 2000m above sea
level.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for
commercial or industrial use under any circumstances. Any incorrect use or
improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as
the one indicated on the product label.
The mains connection cable must not be tangled or wrapped around the product
during use.
Do not use the device, or connect and disconnect to the supply mains with the
hands and / or feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle
Unplug the product immediately from the mains in the event of any breakdown or
damage and contact an official technical support service. In order to prevent
any risk of danger, do not open the device. Only qualified technical personnel
from the brand´s Official technical support service may carry out repairs or
procedures on the device.
B&B TRENDS SL disclaims all liability for damages that may occur to people,
animals or objects, for the non-observance of these warnings.
HOW TO USE THE MACHINE
-
In order to lift the arm, clockwise rotation the Rise knob (2) . The arm will now move upwards. (RC. 1) (Step1)
-
Place the pot cover into its body. (RC. 2) (Step2)
-
Place the mixing bowl into its holding device (RC. 3) (Step3) and turn the bowl clockwise until it locks into place (RC. 3) (Step4).
-
Mount the required utensil (Dough hook or Beater or Whisk) by inserting the top into the output shaft (RC. 4) (Step5) and turn anti-clockwise until it locks into place (RC. 5) (Step6).
-
Now fill in your ingredients.
Do not overfill the machine – the maximum quantity of ingredients is 1.5 kg. -
Clockwise rotation the Rise knob (2): Press the head of the machine, the machine will automatically lock the rise button (2) (RC. 6) (Step7), which is in the horizontal position. If you didn’t clockwise rotation the rise button (2), you can’t press the head of the machine, finally the rise button (2) return to the vertical position when the rise button (2) is locked.
-
Insert the mains plug into a properly installed 220-240V 50-60 Hz safety power socket.
-
Switch the machine using the speed knob to a speed between 1 and 10 (corresponding to the mixture).
-
For pulse operation (kneading at short intervals), turn the switch to the “PULSE” position. The switch has to be held in this position according to the desired interval length. When the switch is released it returns automatically to the “0” position.
-
After kneading/stirring turn the speed knob (3) back to the “0” position as soon as the mixture has formed a ball. Then remove the mains plug.
-
Push the rise knob (2) downwards and the arm will be raised.
-
The mixture can now be released with the help of a spatula and removed from the mixing bowl.
-
The mixing bowl can now be removed.
-
Clean the parts as described under “Cleaning” .
SUGGESTION
Adjusting the Levels and Using the Hook for not more than 1,5kg of Mixture
Accessories| Picture| Speed| Time min.| Maximum|
Operation method
---|---|---|---|---|---
Dough hook| | 1-6| 3-5| 1000g flour +538g water| 1 speed run for 10s, the
2 speed run for 20s, and then the 3 speed run 30s the 5-6 speed run for 2 min
to 4 min to form a cluster.
Dough hook| | 1-7| 3-10| 660g flour +840g water| 1-2 speed run for 30s, the
3-7 speed run for more than 2min 30s, 10 speed run for 7 min (MAX)
Beater| | 8-10| 3-10| 10 eggs| Ompneanti)30v-1e0, speed to raku;(1).3
ANALYSIS OF COMMON PROBLEMS
| Problem | Causes | Solutions |
|---|---|---|
| The machine suddenly stops working during use. | It may be that the machine |
runs too long, or the ambient Tempe- orature is too high, resulting in the
machine’s motor temperature be- ink too high; the machine starts the
overheating protection program, automatic shutdown.| Gear reset to “0”, unplug
the power, wait for the machine to return to room temperature can be restarted
(generally need 15-30 minutes, the room temperature varies cooling time).
Turning the gear knob machine does not run| Check if the plug is in good
contact with the socket.| Verify that the power plug is plug- ged into the
outlet
Check if the power is out.| Wait for power before operating
Check if the rise button spring back in place.| Make sure the headstock is
stuck in place.
Excessive noise when the machine is running| 1 The machine will work louder in
high gear than in low gear.
2 The amount of food stirred is too large, resulting in overloading the
machine.
3 Voltage is unstable.
4 Working time is too long.| 1 Choose the right gear to stir food according to
the recommendations in the manual
2 Reduce the amount of stirring.
3 If the voltage is unstable, wait for the voltage to stabilize before using.
4 If the working time is too long, stop and cool down for a while before
using.
The machine speed drops, or the speed is unstable| 1 Whether the room
temperature is low, causing the lubricant in the machine to harden.
2 The ingredients stirred are too hard and too much, resulting in too much
load on the machine.
3 Whether the voltage suddenly becomes low.| 1 Remove the mixing bowl and let
the machine idle for 5 minutes to soften the lubricant in the machine and
restore the speed stability.
2 Reduce the mixing volume and let the machine work according to the normal
workload.
3 When the voltage is stable, use the machine again.
Machine swaying and shaking when working| 1 Check if the foot pad on the base
is off.
2 Whether the machine is placed on a smooth and flat countertop for use.| 1
Check if the foot pad on the base is off.
2 Place on a smooth and flat count- treetop for use
The headstock can’t spring back to reset after putting on the an- ti-splash
cover and mixing bowl| Check that the anti-splash cover is in place and the
mixing bowl is assembled.| Rotate the anti-splash cover and assemble it in
place, and assemble the mixing pot in place.
Dough darkening found after use| Black powder falls onto the dough at the
mixing head.| Please check that the mixing head and hook are dry and that no
water or dust is present on the surface before use.
CLEANING
Body Cleaning| 1. Do not immerse the machine in the water. Do not use water
to shower di- erectly on top of the machine to prevent the host body from
entering the water to avoid short circuits, electric shock, leakage, rust, and
other failures.
2. Do not use a dripping wet towel to wipe the machine
3. Do not use detergent/vinegar/salt and other corrosive, strongly acidic,
strong alkaline cleaning products to clean the machine body, otherwise aces-
sable to damage the machine’s surface.
4. Do not use sharp and rough tools such as wire balls to brush the access-
stories. Otherwise, it is easy to damage the surface of the accessories.
---|---
Accessory Cleaning| 1. Do not put the cast aluminum parts into the dishwasher
or wash them with corrosive, strongly acidic, or alkaline cleaning products.
Please do not put them into the dishwasher for cleaning. (Except for stainless
steel parts or surface-treated Teflon parts and electrophoresis parts)
2. Do not soak for a long time in detergent, saltwater, vinegar, and other
corrosive liquids; use in time to clean accessories.
3. After cleaning, dry the accessories, mainly to keep the internal parts dry
in time.
Special Cleaning| 1. The rotating output shaft will produce a bit of black
trace due to high speed and friction when the machine is working. After each
use, please clean it promptly and keep the part dry.
2. Pay attention to the sharp blade and related sharp edge parts or access-
stories.
Preservation and maintop- nonce| 1. You can use olive oil to apply on the
blade’s surface, knife plate, and mixing pot to ensure the dry and wet
environment to oxidize it.
2. When not in use, you can cover the machine with a packaging bag and place
it in a dry environment.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and electronic devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal framework applicable in the European Union for the disposal and reuse of waste electronic and electrical devices. Do not dispose of this product in the bin, instead going to the electrical and electronic waste collection center closest to your home.
WARRANTY REPORT
B&B TRENDS, S.L. guarantees compliance of this product for the use for which it is intended for a period of two years. In the case of breakdown during the term of this warranty, users are entitled to repair or else the replacement of the product at no charge if the former is unavailable, unless one of these options proves impossible to fulfill or is disproportionate. In this case, you can then opt for a reduction in price or cancellation of the sale, which must be dealt with directly with the sales vendor. This also covers replacement of spare parts provided that the product has been used according to the recommendations specified in this manual for both cases, and has not been tampered with by any third party that is not authorised by B&B TRENDS, S.L. The warranty will not cover any parts subject to wear and tear. This warranty does not affect your rights as a consumer in accordance with the provisions in Directive 1999/44/EC for member states of the European Union.
USE OF WARRANTY
Customers must contact a B&B TRENDS, S.L. authorised Technical Service for
repair of the product.
Since any tampering of the same by anyone not authorised by B&B TRENDS, S.L.,
or the careless or improper use of the same shall render this warranty null
and void. The warranty must be fully completed and delivered along with the
receipt or delivery docket for the effective exercise of rights under this
warranty.
This warranty should be retained by the user as well as the invoice, receipt
or the delivery docket to facilitate the exercise of these rights. For
technical service and after-sales care outside the Polish territory, please
submit your query to the point of sale where you purchased the item or check
for further aftersales information at www.zelmer.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>