zelmer ZKR1300W Stand Mixer User Manual
- June 3, 2024
- zelmer
Table of Contents
zelmer ZKR1300W Stand Mixer
WE WOULD LIKE TO THANK YOU FOR CHOOSING ZELMER. WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT.
STORE THESE IN A SAFE PLACE FOR FUTURE REFERENCE
DESCRIPTION
- Output shaft
- Rise button
- Speed button
- Bowl
- Dough hook
- Beater
- Whisk
- Bowl cover
SAFETY INSTRUCTIONS
If the supply cord is damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Respect the operating times of the accessories indicated in their specific sections of the manual. Proceed according to the maintenance and cleaning section of this manual for cleaning.
Warning: potential injury from misuse!
Always disconnect the appliance from the supply if it is left unattended
and before assembling, disassembling or cleaning. Switch off the appliance and
disconnect from the supply before changing accessories or approaching parts
that move in use. This appliance shall not be used by children. Keep the
appliance and its cord out of reach of children. Appliances can be used by
persons with reduced physical, sensory or mental capabilities or lack of
experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and if they understand the hazards involved.
Children shall not play with the appliance.
This appliance is intended for use at a maximum altitude
of 2000m above sea level.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commercial or industrial use under any circumstances. Any incorrect use or improper handling of the product shall render the warranty null and void. Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the product label.
The main connection cable must not be tangled or wrapped around the product
during use. Do not use the device, or connect and disconnect to the supply
mains with the hands and/or feet wet. Do not pull on the connection cord in
order to unplug it or use it as a handle Unplug the product immediately from
the mains in the event of any breakdown or damage and contact an official
technical support service. In order to prevent any risk of danger, do not open
the device. Only qualified technical personnel from the brand´s Official
technical support service may
carry out repairs or procedures on the device.
B&B TRENDS SL disclaims all liability for damages that may occur to people, animals or objects, for the non-observance of these warnings.
HOW TO USE THE MACHINE
- In order to lift the arm, clockwise rotation the Rise knob (2) . The arm will now move upwards. (RC. 1) (Step1)
- Place the pot cover into its body. (RC. 2) (Step2)
- Place the mixing bowl into its holding device (RC. 3) (Step3) and turn the bowl clockwise until it locks into place (RC. 3) (Step4).
- Mount the required utensil (Dough hook or Beater or Whisk) by inserting the top into the output shaft (RC. 4) (Step5) and turn anti-clockwise until it locks into place (RC. 5) (Step6).
- Now fill in your ingredients. Do not overfill the machine – the maximum quantity of ingredients is 1.5 kg.
- Clockwise rotation the Rise knob (2): Press the head of the machine, the machine will automatically lock the rise button (2) (RC. 6) (Step7), which is in the horizontal position. If you didn’t clockwise rotation the rise button (2), you can’t press the head of the machine, finally the rise button (2) return to the vertical position when the rise button (2) is locked.
- Insert the mains plug into a properly installed 220-240V 50-60 Hz safety power socket.
- Switch the machine using the speed knob to a speed between 1 and 10 (corresponding to the mixture).
- For pulse operation (kneading at short intervals), turn the switch to the “PULSE” position. The switch has to be held in this position according to the desired interval length. When the switch is released it returns automatically to the “0” position.
- After kneading/stirring turn the speed knob (3) back to the “0” position as soon as the mixture has formed a ball. Then remove the mains plug.
- Push the rise knob (2) downwards and the arm will be raised.
- The mixture can now be released with the help of a spatula and removed from the mixing bowl.
- The mixing bowl can now be removed.
- Clean the parts as described under “Cleaning”.
SUGGESTION
Adjusting the Levels and Using the Hook for not more than 1,5kg of Mixture
ANALYSIS OF COMMON PROBLEMS
| Problem | Causes | Solutions |
|---|---|---|
| The machine suddenly stops working during use. | It may be that the machine |
runs too long, or the ambient tempe- rature is too high, resulting in the
machine’s motor temperature be- ing too high; the machine starts the
overheating protection program, automatic shutdown.| Gear reset to “0”, unplug
the power, wait for the machine to return to room temperature can be restarted
(generally need 15-30 minutes, the room temperature varies cooling time).
Turning the gear knob machine does not run| Check if the plug is in good
contact with the socket.| Verify that the power plug is plug- ged into the
outlet
Check if the power is out.| Wait for power before operating
Check if the rise button spring back in place.| Make sure the headstock is
stuck in place.
Excessive noise when the machine is running| 1 The machine will work louder in
high gear than in low gear.
2 The amount of food stirred is too large, resulting in overloading the machine.
3 Voltage is unstable.
4 Working time is too long.
| 1 Choose the right gear to stir food according to the recommendations in the manual
2 Reduce the amount of stirring.
3 If the voltage is unstable, wait for the voltage to stabilize before using.
4 If the working time is too long, stop and cool down for a while before using.
The machine speed drops, or the speed is unstable| 1 Whether the room temperature is low, causing the lubricant in the machine to harden.
2 The ingredients stirred are too hard and too much, resulting in too much load on the machine.
3 Whether the voltage suddenly becomes low.
| 1 Remove the mixing bowl and let the machine idle for 5 minutes to soften the lubricant in the machine and restore the speed stability.
2 Reduce the mixing volume and let the machine work according to the normal workload.
3 When the voltage is stable, use the machine again.
Machine swaying and shaking when working| 1 Check if the foot pad on the base is off.
2 Whether the machine is placed on a smooth and flat countertop for use.
| 1 Check if the foot pad on the base is off.
2 Place on a smooth and flat coun- tertop for use
The headstock can’t spring back to reset after putting on the anti-splash
cover and mixing bowl| Check that the anti-splash cover is in place and the
mixing bowl is assembled.| Rotate the anti-splash cover and assemble it in
place, and assemble the mixing pot in place.
Dough darkening found after use| Black powder falls onto the dough at the
mixing head.| Please check that the mixing head and hook are dry and that no
water or dust is present on the surface before use.
CLEANING
Body Cleaning| 1. Do not immerse the machine in the water. Do not use water to shower di- rectly on top of the machine to prevent the host body from entering the water to avoid short circuits, electric shock, leakage, rust, and other failures.
2. Do not use a dripping wet towel to wipe the machine
3. Do not use detergent/vinegar/salt and other corrosive, strongly acidic, strong alkaline cleaning products to clean the machine body, otherwise acces- sible to damage the machine’s surface.
4. Do not use sharp and rough tools such as wire balls to brush the acces- sories. Otherwise, it is easy to damage the surface of the accessories.
---|---
Accessory Cleaning| 1. Do not put the cast aluminum parts into the dishwasher
or wash them with corrosive, strongly acidic, or alkaline cleaning products.
Please do not put them into the dishwasher for cleaning. (Except for stainless
steel parts or surface-treated Teflon parts and electrophoresis parts)
2. Do not soak for a long time in detergent, saltwater, vinegar, and other corrosive liquids; use in time to clean accessories.
3. After cleaning, dry the accessories, mainly to keep the internal parts dry in time.
Special Cleaning| 1. The rotating output shaft will produce a bit of black trace due to high speed and friction when the machine is working. After each use, please clean it promptly and keep the part dry.
2. Pay attention to the sharp blade and related sharp edge parts or acces- sories.
Preservation and mainte- nance| 1. You can use olive oil to apply on the blade’s surface, knife plate, and mixing pot to ensure the dry and wet environment to oxidize it.
2. When not in use, you can cover the machine with a packaging bag and place it in a dry environment.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and
electronic devices, known as WEEE (Waste Electrical and Electronic Equipment),
and provides the legal framework applicable in the European Union for the
disposal and reuse of waste electronic and electrical devices. Do not dispose
of this product in the bin, instead go to the electrical and electronic waste
collection centre closest to your home.
WARRANTY REPORT
B&B TRENDS, S.L. guarantees the compliance of this product for the use for which it is intended for a period of two years. In the case of a breakdown during the term of this warranty, users are entitled to repair or else the replacement of the product at no charge if the former is unavailable unless one of these options proves impossible to fulfill or is disproportionate. In this case, you can then opt for a reduction in price or cancellation of the sale, which must be dealt with directly with the sales vendor. This also covers the replacement of spare parts provided that the product has been used according to the recommendations specified in this manual for both cases, and has not been tampered with by any third party that is not authorized by B&B TRENDS, S.L. The warranty will not cover any parts subject to wear and tear. This warranty does not affect your rights as a consumer in accordance with the provisions in Directive 1999/44/EC for member states of the European Union.
USE OF WARRANTY
Customers must contact a B&B TRENDS, S.L. authorised Technical Service for the
repair of the product. Since any tampering of the same by anyone not
authorised by B&B TRENDS, S.L., or the careless or improper use of the same
shall render this warranty null and void. The warranty must be fully completed
and delivered along with the receipt or delivery docket for the effective
exercise of rights under this warranty.
This warranty should be retained by the user as well as the invoice, receipt or delivery docket to facilitate the exercise of these rights. For technical service and after-sales care outside the Polish territory, please submit your query to the point of sale where you purchased the item or check for further after-sales information at www.zelmer.com.
B &B TRENDS, S.L.
C. Cataluña, 24 · P.I. Ca N’Oller
08130 Santa Perpètua de Mogoda
(Barcelona) · Spain. WWW.ZELMER.COM.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>