SEALEY LED3000 Rechargeable Portable Floodlight and Power Bank Instructions
- June 16, 2024
- SEALEY
Table of Contents
SEALEY LED3000 Rechargeable Portable Floodlight and Power Bank
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
GENERAL
- Use this light only as it is intended.
- Inspect before every use.
- Keep away from infants and toddlers as this product contains small parts.
- Protect this product from water, humidity or any liquids.
- DO NOT stare into the light, shine light into eyes or focus the beam using an additional lens.
- DO NOT use the light if you suspect that the battery or product casing is damaged.
- DO NOT attempt to repair/disassemble the light yourself.
- DO NOT leave batteries in a discharged state. Before storage remove batteries.
- DO NOT use/store the product in extreme temperatures.
BATTERY SAFETY
WARNING! This product contains a non-replaceable rechargeable lithium
battery. Attempting to open the product or replacing the rechargeable battery
will result in permanent damage and void all warranties.
WARNING! To reduce the risk of burns or fire:
- DO NOT attempt to open the batteries.
- DO NOT crush, puncture, short contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 60°C (140°F).
- Recycle or dispose of used batteries as stipulated by local regulation.
- If the electrolyte in the batteries gets on your skin, rinse thoroughly with water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
INTRODUCTION
30W COB LED Compact portable floodlight. 3 modes of light ranging from 300-3000lm. Rechargeable high-quality 3.7V battery. 180°curve for a wide spread of light. Adjustable stand for positioning of light. Supplied with 50cm Type-C USB Charging cable. Charging time 8.5 Hours. Water and Impact resistant. Power bank output 5V 1A.
SPECIFICATION
MODEL NO: | LED3000 |
---|---|
Battery: | 3.7V 4Ah (x2) |
Charging Time: | 8.5hrs |
IP Rating: | IPX6 |
LED Type: | COB |
Lumen Output: | 3000lm |
Operating Time: | Mode 1- 1hr 40 mins |
Mode 2- 3 Hr 40 mins
Mode 3 – 7hr 30 mins
Power:| 30W
USB Output:| 5V 1A
OPERATION
CHARGING (FIG.2)
This product is rechargeable. Please charge fully before first use to ensure
optimal performance. Pull up the rubber port cover on the back of the light.
Connect the USB-A to a USB power source such as a power cube, computer or car
adapter and the USB-C plug into the charging port. A green four-step charging
indicator flashes. Charging is complete when all 4 lights turn solid green. DO
NOT USE THE WORK LIGHT WHILE IT IS CHARGING!
POWER BUTTON (FIG.2)
Repeatedly pressing the power button cycles between high, medium and low
brightness settings, plus off.
KICKSTAND (FIG.1)
The kickstand locks in 6 positions and may also be used as a carry handle.
CHARGING A SMARTPHONE (FIG.2)
Pull up the rubber port cover. Using your phone charging cable, connect the
full-sized U SB plug into the flashlight’s USB power bank port. Connect the
other end to your device. NOTE: Charging a smartphone reduces the overall
runtime of the work light. Replace the port cover when finished.
MAINTENANCE
- Clean this product with a soft, slightly damp cloth.
- DO NOT use any abrasive agents to clean the product.
- DO NOT attempt to repair/disassemble the light yourself.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner that is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries
(as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration
Number (BPRN) is BPRN00705.
- Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
- Important: No Liability is accepted for incorrect use of this product.
- Warranty: The guarantee is 12 months from the purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk www.sealey.co.uk.
© Jack Sealey Limited.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>