‎Streamlight 66134 Stylus Pro Rechargeable LED Pen Light User Guide

‎Streamlight 66134 Stylus Pro Rechargeable LED Pen Light

Specification

Important!

• a. You must charge the battery before using the Stylus Pro® COB to disable the packaged “Try Me Mode” functionality.
• b. Once the light is charged, the light will function as described below in Light Function.

USING THE LIGHT

• Push button switch – constant on operation. High/Low/Off.

• With the light on, press and hold the button for three seconds to access flash mode. Press and hold again to go back to standard operation.

• The light uses Streamlight’s (660 mAh) Lithium Ion cell pack with on board safety circuit. Rechargeable up to 300 times.
  NOTE: when you get to 300 charges the battery will take approximately 70% of the original charge value.

• Push in rubber cover protects the Micro USB charging port from debris and water infiltration.

CHARGING INFORMATION

Fully charge your flashlight before first use.

• To charge the battery – peel the rubber cover back to expose the micro USB connector.

• Using the supplied cord, plug the micro USB connector into the mating socket on the light. Plug the standard USB connector into a USB port on your computer or other USB-accessible port.

• Charge indication LED: LED Red – Charging; LED Green – Charged.
  NOTE – If there is no battery in the light, both the Red and Green charge indicator will light up simultaneously.

• The light has a digital control circuit that prevents overcharge. The battery fully recharges in 4.5 hours and charges the battery in the light. (4.5 HR charge time assumes 500 mA output USB connection. USB power ports can range from 100 to 500 mA)
  NOTE – The light does not need to be in the off position to charge light. However, if the light is on (lit) when the user plugs the USB cord into the USB power source, the light will extinguish. When the user unplugs the light from the USB power source the light resets to the off position.

• 3-Hour Run Time – NOTE – In the last 30 minutes the light will drop off dramatically.
  There are “no end of run time notifications”, the light will simply turn off.

BATTERY REPLACEMENT

To replace the Streamlight Li-Ion cell. Remove the tail cap by rotating it counterclockwise. Slide the battery out and replace it with a Streamlight 66143 lithium battery. Slide the new battery into the barrel with the positive end entering the barrel first. Replace the tail cap.

PRODUCT REGISTRATION: To register your product, go to www.streamlight.com (Online Product Registration). Retain your receipt or any proof of purchase.

WARNING: Be sure to use only genuine Streamlight® replacement parts.

Important: To assure product safety and reliability, repairs other than those listed below should be performed at the Streamlight factory. Always use Streamlight approved replacement parts, substitution may invalidate the underwriter’s approval.

Streamlight’s Limited Lifetime Warranty

Streamlight warrants this product to be free of defects for a lifetime of use except for batteries and bulbs, abuse, and normal wear. We will repair, replace or refund the purchase price of this product should we determine it to be defective. This limited lifetime warranty also excludes rechargeable batteries, chargers, switches, and electronics which have a 2-year warranty with proof of purchase. THIS IS THE ONLY WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. INCIDENTAL, CONSEQUENTIAL, OR SPECIAL DAMAGES ARE EXPRESSLY DISCLAIMED EXCEPT WHERE SUCH LIMITATION IS PROHIBITED BY LAW. You may have other specific legal rights which vary by jurisdiction.

Go to www.streamlight.com/support for a complete copy of the warranty, information on product registration, and the location of authorized service centers. Retain your receipt for proof of purchase.

SERVICE

Go to www.streamlight.com for the location of an authorized Streamlight repair center near you.

Contact us at:

Customer Service STREAMLIGHT, INC. 30 Eagleville Road Suite 100 Eagleville, PA U.S.A. 19403-39996

• Phone: 800-523-7488 Toll-Free or 610-631-0600
• Fax: 800-220-7007 or 610-631-0712

FAQs

How do I know when the battery is fully charged?****

The battery will charge to full capacity in approximately 2 hours. When the battery is fully charged, the charging LED will turn green.

How long will it take to charge the battery?****

It takes approximately 2 hours to charge the battery from a completely drained state.

Will I be able to use my Stylus Pro® COB while it is charging?****

Yes, you can use your Stylus Pro® COB while it is charging. However, if you are using your Stylus Pro® COB in a cold environment, we recommend that you remove the battery from the light and place it in a warm environment to ensure that the battery reaches its full capacity before you begin using your light.

How do I know when my battery needs to be recharged?****

If your Stylus Pro® COB has been used for an extended period of time, you may notice that your beam does not shine as brightly as when you first began using your light. This is normal and indicates that your battery needs to be recharged. To recharge, simply plug in the micro USB cord into a USB port on your computer or other USB-accessible port

How long do Pen lights last?****

The pen light can operate for a maximum of 7 hours on 2 AAA batteries (not included). EXCELLENT QUALITY — The body of the flashlight is made of corrosion-resistant aircraft aluminum, which may improve heat dissipation.

How long do pen Lights last?****

The pen light can operate for up to 7 hours on two AAA batteries (not included). EXCELLENT QUALITY — The body of the flashlight is made of corrosion-resistant aircraft aluminum, which may improve heat dissipation.

What is the purpose of pen light?****

The most popular instrument for measuring pupil diameter now incorporates a light source and is a penlight. One pupil contracts in reaction to light, whereas the other either doesn’t contract at all or contracts more slowly.

How bright should a pen light be?****

It will be sufficient with about 100 lumen. Also, it shouldn’t be detrimental. Hence, a medical pen light will have a warm white CRI.

How many batteries does a light up pen take?****

Requires 3 button cell batteries (LR41), which are not provided but may be changed with a battery blocker that needs to be taken off before use

Which devices allows the use of a light pen?****

Any CRT-based monitor may utilize it. In their original form, these tools were used to draw attention to and alter a display item. The light pen works well with CRT monitors because they can scan the screen.

Why is the light pen called as an input device?****

Also an optical input device, the light pen. This tool is made to aim at and fire at targets displayed on a screen in an arcade or video game. The MIT Whirlwind computer also saw the first usage of a light cannon. By aiming it towards a target on the screen, the gadget operates.

How do you test a penlight?****

Swing the penlight smoothly to the left eye, keeping it on, and look at the pupil size (it should stay small). 12. Swing your eyes back and forth two or three times. As the light in a room is lowered, pupils dilate (become bigger).

Product Description Video

Download the PDF Link;‎Streamlight Stylus Pro Rechargeable LED Pen Light pdf

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>