RIDGID PC-116 TS Tube Stand Instructions
- June 9, 2024
- RIDGID
Table of Contents
RIDGID PC-116 TS Tube Stand Instructions
Safety Instruction
Warning
| Read these instructions and the warnings and instructions for all equipment
and material being used before operating this tool to reduce the risk of
serious personal injury.
---|---
SAVE THESE INSTRUCTIONS!
-
Position the PC116TS Tube Stand on a clear, level, stable location.
This will reduce the risk of tipping. -
Properly support tubing. Failure to properly support tubing can cause stand tipping, falling tubes and serious injury.
-
Use the PC116TS Tube Stand only with PC116/PTC-400 Power Tubing Cutter.
Description
RIDGID® PC116TS Tube Stand is for use with PC116/PTC-400 Power Tubing Cutter to support tubing.
Specifications
- Tube Size: 1/2″– 4.5″ (12-120 mm)
- Weight Capacity: 110 lbs. (50 kg)
- Height Adjustment: 1″ (25 mm)
Figure 1 – PC116TS Tube Stand
Inspection/Maintenance
Clean the PC116TS Stand to aid inspection and improve control.
Inspect before each use for proper assembly, wear, damage, modification or
other issues that could affect safe use.
If any problems are found, do not use until corrected.
Lubricate all moving parts/joints as needed with light lubricating oil.
Wipe up excess oil.
Set-Up and Operation
-
Make sure all equipment is inspected and set up per its instructions.
-
Locate a clear, level, stable location for the stand, other equipment and the operator.
-
To adjust ball rollers for tube size:
- Depress button.
- Move ball head to proper tube size position (see Figure 1).
- Release button – confirm securely located.
-
To adjust stand height, turn collar to raise or lower stand head. Stand is designed to be placed on the same flat surface as the PC116/PTC-400
Cutter. If needed, suitable spacers (such as a piece of wood) can be used to raise stand. -
Place stands in line with PC116/PTC-400 rollers to properly support the tubing.
Generally, tubing should be supported in at least two places.
The number and placement of stands depend on the specific circumstances, including tubing size, length and weight. -
Carefully place the tubing on the stands. Make sure that the tubing is properly centered on the stands to reduce the risk of tipping.
Do not drop the tubing onto the stands.
Do not exceed the stand ratings.
Make sure tubing is stable and secure.
Always stay clear of supported loads.
CUSTOMER SUPPORT
Tel: 1.888.610.7664
Email:sales@calcert.com
Web: www.calcert.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>