RIDGID R84088 18V Cordless Speaker Instruction Manual

June 3, 2024
RIDGID

RIDGID logoRIDGID R84088 18V Cordless Speaker IMPORTANT SAFETY INSTRUCTIONS

WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.
READ THESE INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury.

READ THESE INSTRUCTIONS
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS

  • Clean only with dry cloth.
  • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
  • Only use attachments/accessories specified by the manufacturer.
  • Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
  • Know your product. Read operator’s manual carefully. Learn its applications and limitations, as well as the specific potential hazards related to this product. Following this rule will reduce the risk of electric shock, fire, or serious injury.
  • Do not operate products in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Products create sparks which may ignite the dust or fumes.
  • Do not use this apparatus near water.

ELECTRICAL SAFETY

  • A battery operated product with integral batteries or a separate battery pack must be recharged only with the specified charger for the battery. A charger that may be suitable for one type of battery may create a risk of fire when used with another battery.
  • Use battery operated product only with specifically designated battery pack. Use of any other batteries may create a risk of fire.
  • For use with 18 V lithium-ion battery packs, see tool/appliance/battery pack/charger correlation supplement 988000-302.

PERSONAL SAFETY

  • Do not use on a ladder or unstable support. Stable footing on a solid surface enables better control of the product in unexpected situations.
  • Do not use the speaker to listen to music or other audio programs while operating machinery. Doing so may cause distractions that could result in serious personal injury.
  • This speaker is capable of producing sound levels that can be dangerous to long-term hearing. Listening to music at high volume for any period of time may cause noise-induced hearing loss. The higher the volume, the less time required before your hearing may be affected.

PRODUCT USE AND CARE

  • When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns, or a fire.
  • Keep the speaker and its handle dry, clean and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any strong solvents to clean the speaker. Following this rule will reduce the risk of loss of control and deterioration of the enclosure plastic.
  • Battery products do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. Be aware of possible hazards when not using your battery product or when changing accessories. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.
  • Do not place battery products or their batteries near fire or heat. This will reduce the risk of explosion and possibly injury.
  • Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has been dropped or received a sharp blow. A damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.
  • Batteries can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.
  • Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.
  • To reduce the risk of personal injury and electric shock, the product should not be played with or placed where small children can reach it.

BATTERY TOOL USE AND CARE

  • Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
  • Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
  • When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
  • Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
  • Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
  • Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or temperature above 265° F may cause explosion.
  • Follow all charging instructions and do not charge the battery pack or tool outside the temperature range specified in the instructions. Charging improperly or at temperatures outside the specified range may damage the battery and increase the risk of fire.

SERVICE

  • When servicing a product, use only identical replacement parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of shock or injury.
  • Save these instructions. Refer to them frequently and use them to instruct others who may use this product. If you loan someone this product, loan them these instructions also.

SYMBOLS

RIDGID R84088 18V Cordless Speaker fig 7 RIDGID R84088 18V Cordless Speaker fig 8

ASSEMBLY

WARNING:
Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. Always remove battery pack from the product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. The speaker is not waterproof. Do not submerge in liquid. Failure to heed this warning could result in serious personal injury.

NOTICE :
Always refer to the manual for any device recommended for use as an attachment or accessory. Proper use of any device, when attached to the speaker, is the sole responsibility of the operator. Improper use may damage the device or the product.

APPLICATIONS

You may use this product for the following purposes:

  • BLUETOOTH® audio streaming, charging USB-capable devices up to 2 Amp

INSTALLING/REMOVING BATTERY PACK

RIDGID R84088 18V Cordless Speaker fig 1RIDGID
R84088 18V Cordless Speaker fig 2 To install battery pack:

  • Align the ribs on the battery pack with the grooves in the speaker’s battery port and place the battery pack in the speaker as shown.
  • Make sure the latches on the battery pack snap into place and the battery pack is secured to the speaker before beginning operation.

NOTE: Leaving the battery pack connected for long periods of time will drain the battery pack. Always disconnect bat-tery pack after use.
To remove battery pack:

  • Depress the latches on both sides to release the battery pack from the speaker.
    NOTE: Always remove battery pack from speaker when not in use.

CONTROL BUTTONS

RIDGID R84088 18V Cordless Speaker fig 3
Use the control buttons to turn the speaker on and off, connect or disconnect BLUETOOTH® devices and control the volume.
NOTE: The USB charging port beside the control buttons can be used to charge small USB devices.

TURNING THE SPEAKER ON AND OFF:
Press the on/off button to turn the speaker on and off. When the speaker is on, a battery pack is installed, and a BLUETOOTH® enabled device is paired, the light will turn solid. If the device is not connected the light will flash slowly. If the battery charge is low, the light will fade on and off.

NOTE: When the battery charge is low, the speaker will say “Battery Low”.
DISCONNECTING BLUETOOTH® DEVICES:
Press and hold the BLUETOOTH® button for three seconds to disconnect a paired BLUETOOTH® device.
ADJUSTING THE VOLUME:

  • To increase the volume, press the + button.
  • To decrease the volume, press the – button.

NOTE: Volume for any connected device can be adjusted using the volume control for that device and/or with the + or – buttons on the product.
PAUSE AND PLAY:

  • Briefly press and release the BLUETOOTH® button to cycle between pausing and playing the audio.

USING A BLUETOOTH® ENABLED DEVICE (NOT INCLUDED) WITH THE SPEAKER

RIDGID R84088 18V Cordless Speaker fig 4

  • Install a battery pack and turn the speaker on.
    NOTE: The speaker will say “Power On” and automatically attempt to connect to the last device it was paired to. If no device has been previously paired, the will flash.

  • Set your device to search/scan for available BLUETOOTH® signals, then select “RIDGID Speaker R84088” from the list. No password or PIN is required for connection. NOTE: For best results, BLUETOOTH® enabled devices should be within 50 ft. of the speaker and set to search/scan in order to pair with the speaker.

  • When the device has successfully paired with the speaker, the speaker will say “Bluetooth Connected” and the will turn solid.
    NOTE: If the speaker does not pair with your device, turn the power to the speaker off, wait 5 seconds, then turn the power back on and start the pairing process again. When a device is paired to the speaker, information for connecting to the device is saved in the speaker’s memory.

  • To disconnect the BLUETOOTH® enabled device, press and hold the BLUETOOTH® button for three seconds. When the device is disconnected, the speaker will say “BLUETOOTH® disconected”, the will flash, and the speaker will search for a BLUETOOTH® signal.
    NOTE: The speaker will not automatically connect to the device it was just disconnected from.

USING THE USB DEDICATED CHARGING PORT

RIDGID R84088 18V Cordless Speaker fig 6
The USB dedicated charging port provides charging power of 5 Volts DC at up to 2 Amp for your cell phone, MP3 player, or other USB devices.
NOTICE: Attempting to charge devices rated more than 2.1 Amp, such as a tablet, could damage the USB dedicated charging port and/or the device.

  • Connect one end of a USB cable (not provided) to your USB device.

  • Connect the other end of the USB cable (not provided) to the USB dedicated charging port to begin charging the device.
    NOTE: The USB dedicated charging port provides power only; it does not provide any data communication capabilities.

  • The USB dedicated charging port will continue to function as long as the speaker is on. If the speaker is off, charging will stop.
    NOTE:
    The speaker will turn off in 30 minutes if no audio has been streamed.
    Turn the speaker on to resume operation. Maintenance information begins on page 7 after French and Spanish language sections. Illustrations start on page

  1. This product has a 90-Day Satisfaction Guarantee Policy, as well as a Three-year Limited Warranty. For Warranty and Policy details, please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.

FCC COMPLIANCE

WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IC regulatory conformance
This device complies with CAN ICES-003 (B)/NMB-003(B) and CAN RSS-216 / CNR-216.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  • This device may not cause interference.
  • This device must accept any interference, including interference that may cause undesired operation of the device.
    RF Exposure

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

RIDGID 18V SPEAKER WITH BLUETOOTH® WIRELESS TECHNOLOGY Model: R84088
The responsible party declares that this device complies with Part 15 of the FCC Rules. Operation is subject to the follow-ing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Responsible Party: Techtronic Cordless GP
Address: 115 Innovation Way, Anderson, SC 29621
Telephone: 864-360-3359
Printed Name/Title: John Collins / Director Regulatory

To register your RIDGID product, please visit: register.RIDGIDpower.com

Customer Service Information:
For parts or service, do not return this product to the store. Contact your nearest RIDGID® authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us online at powertools.ridgid.com.
MODEL NO.
SERIAL NO
Model number on product may have additional letters at the end. These letters designate manufacturing information and should be provided when calling for service.
TTI CONSUMER POWER TOOLS, INC.
P.O. Box 1427
Anderson, SC 29622 USA
1-866-539-1710  powertools.ridgid.com
RIDGID is a registered trademark of RIDGID, Inc., used under license.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals